Beurer JIH50 [27/132] Operation

Beurer JIH50 [27/132] Operation
27
Operating the device with the power
pack
Connect the power pack (13) only to the
mains voltage listed on the type plate.
Open the battery compartment lid to
connect the power pack (13).
Insert the power pack connector (8) into
the connection socket (15) provided,
and the power pack (13) fully into a
suitable socket.
Note:
Ensure that there is a socket near to
where the device will stand.
Lay the mains cable in such a way that
no one can trip over it.
To disconnect the nebulizer from the
mains after use, first switch off the device
and then remove the power pack from the
socket (13).
Do not remove the batteries when operat-
ing the device with the power pack (13).
The power pack (13) cannot be used for
charging batteries.
7 Operation
1 Preparing the nebulizer
For reasons of hygiene, it is imperative that the nebu-
lizer and accompanying accessories are cleaned and
disinfected after every use. If the therapy requires that
various different medicines be inhaled one after an-
other, ensure that the nebulizer is rinsed after every
application.
For details, see Cleaning and disinfection on page 29.
Remove the cover (1) from the device.
Filling the nebulizer
Open the medicine container (2) by lifting the clip,
and fill the medicine container with an isotonic saline
solution or medicine. Do not overfill!
The maximum recommended fill level is 8 ml.
2
Use medication only on the advice of a physician, and check the appropriate
inhalation duration and quantity for your needs.
If the recommended dose of the medicine is less than 2 ml, top up this quantity
to at least 4 ml using only isotonic saline solution. Viscous medicines may also
require dilution. Always follow the instructions of your doctor.
3 Closing the nebulizer
Close the lid of the medicine container (2) and click the clip in place, and then
refit the cover (1).

Содержание

Скачать