Beurer FCE 70 [12/68] Operation

7. Operation

Do not use the ionic facial sauna for more than 20 minutes per day. It is recommended that two to

three treatments are performed per week.

After you have made the necessary preparations described in “Section 6. Initial use”, you may start

the treatment.

To start the treatment, carry out the following steps:

•Connectthemainsplugtothesocketandpressthe

ON/OFFbutton.

The indicator lamp illuminates green. The device

starts to heat the distilled water. After approximately

2 minutes, steam begins to flow from the nozzle. After

approximately 3-4 minutes, the steam is strong enough

and you can begin the treatment.

•Moveyourfaceslowlytowardstheflowofsteamso

that the steam covers your entire face. The steam

should feel pleasant and not too hot. If you feel the

steam is too hot, move further away from the nozzle to

preventburninjuries.

Warning

Ensurethatyourfacedoesnotgetcloserthan25cmto

thenozzle.Otherwisethereisadangerofyourfacialskin

becomingredorsustainingburninjuries.

When there is no longer any water in the device, the indicator lamp turns red.

•NowpresstheON/OFFbuttonandremovethemainscablefromthesocket.

•

After the treatment, wash your face with cold water. Now apply a facial cream or face mask. The

open pores allow the active agents to penetrate deep into the skin.

•Allowthedevicetocooldownfor10minutes.Afterwards,cleanthedeviceasdescribedin

Section “8. Cleaning”.

8. Cleaning

Prior to cleaning, make sure that the mains plug has been removed from the socket.

•Aftereachuse,emptyandcleanthewatercollection

container and remove any grease or other residue.

•Aftercleaning,replacethewatercollectioncontainerin

the device.