Sdmo PERFORM 4500XL [10/24] Switching off
![Sdmo PERFORM 4500XL [10/24] Switching off](/views2/1510432/page10/bga.png)
4.3. Switching off
n Disconnect the electrical sockets (fig. A - No. 10) allowing the engine to run idle for 1 or 2 minutes.
o Set the start & stop control (fig. A - No. 7) to “OFF” or “O": The generating set stops.
p Close the fuel tap (fig. A - ref. 5 & fig. C - No. 1).
Always ensure suitable ventilation for the generating set.
Even after shut down, the engine continues to dissipate heat.
Warning
5. Safety features
5.1. Oil cut-out
If there is no oil in the engine sump or if the oil pressure is low, the oil safety mechanism automatically stops the engine to prevent any
damage.
If this occurs, check the engine oil level and top it up if necessary before looking for any other cause of the problem.
5.2. Circuit breaker
The set's electrical circuit is protected by one or more magnetothermal, differential or thermal cut-out switches. In the event of an
overload and/or short circuit, the supply of electrical energy may be cut.
If necessary, replace the circuit breakers in the generating set with circuit breakers with identical nominal ratings and specifications.
6. Maintenance schedule
6.1. Reminder of use
The maintenance operations to be carried out are described in the maintenance schedule. The interval for this is supplied as a guide
and for generating sets operating with fuel and oil which conform to the specifications given in this manual.
If the generating set is used under extreme conditions, the interval between the maintenance operations must be shortened.
6.2. Maintenance table
Component
Operations to
be carried out
on reaching the
1
st
due date
Each time it is
used
After
1
st
month
or
First 5 hours
Every
3 months
or
Every 50 hours
Every
6 months
or
Every 100 hours
Every
year
or
Every 200 hours
Fastenings Check
•
Engine oil
Check the level
•
Change
•
•
Fuel strainer Clean
•
Sediments bowl Clean
•
Air filter
Check
•
Clean
•
Replace
•
Spark arrester Clean
•
•
Spark plug Check - Clean
•
Generating set Clean
•
Valves * Check - Adjust*
•*
Fuel tank* Clean*
•*
Fuel pipes*
Check (replace
if necessary)
Every 2 years*
* Operation(s) to be entrusted to one of our agents.
In case of use in dusty areas, clean the air filter more frequently.
In case of limited use, drain the oil every year at the latest.
Содержание
- 3 3 5 5 2 2 2 2 1 1 7 7 3 3 4 4 0 0 1 1 _ _ 2 2 _ _ 1 1 1
- P p p e e e r r r f f f o o o r r r m m m 3 3 3 0 0 0 0 0 0 0 0 0 1
- Contents 5
- Instructions and safety regulations 5
- Pictograms and plates on the generating sets and what they mean 5
- Preface 1 recommendations 5
- Checking the oil level 8
- Description 8
- Earthing the generating set 8
- Preparation before use 3 positioning the generating set for operation 8
- Checking the air filter 9
- Checking the fuel level 9
- Operation 9
- Starting procedure 9
- Using the generator set 9
- Circuit breaker 10
- Maintenance schedule 6 reminder of use 10
- Maintenance table 10
- Safety features 5 oil cut out 10
- Switching off 10
- Cleaning the fuel strainer 11
- Cleaning the sediment bowl 11
- Maintenance procedures 7 checking bolts nuts and screws 11
- Renewing the engine oil 11
- Checking the spark plug 12
- Cleaning the air filter 12
- Cleaning the generating set 12
- Cleaning the spark arrester 12
- Storing the generating set 13
- Troubleshooting 13
- Cable sizes 14
- Ec declaration of conformity 14
- Specifications 14
- Правила техники безопасности 15
- Предварительная информация 1 рекомендации 15
- Символы и таблички на генераторных установках и их значение 15
- Содержание 15
- Заземление генераторной установки 18
- Описание генераторной установки 18
- Подготовка перед применением 3 место эксплуатации 18
- Проверка уровня масла 18
- Проверка воздушного фильтра 19
- Проверка уровня топлива 19
- Процедура запуска 19
- Работа установки 19
- Эксплуатация генераторной установки 19
- Выключатель 20
- Выключение установки 20
- Защитные устройства 5 устройство безопасности системы смазки 20
- Порядок технического обслуживания 6 напоминание 20
- Таблица обслуживания 20
- Замена моторного масла 21
- Операции технического обслуживания 7 проверка винтовых соединений 21
- Очистка стакана отстойника 21
- Очистка топливного фильтра 21
- Очистка воздушного фильтра 22
- Очистка генераторной установки 22
- Очистка искрогасителя 22
- Проверка свечи зажигания 22
- Устранение незначительных неисправностей 23
- Хранение генераторной установки 23
- Декларация соответствия нормам ес 24
- Сечение проводов 24
- Характеристики 24
Похожие устройства
- Sdmo PERFORM 3000XL Руководство пользователя
- Grost HED 10/20 (101471) Инструкция по эксплуатации
- Dewalt DCG406N Инструкция по эксплуатации
- Karcher 10921040 1.092-104.0 Инструкция по эксплуатации
- Hammer AMD3.6Li USB Инструкция по эксплуатации
- Bosch Quigo III (0603663522) Инструкция по эксплуатации
- Electrolux ECH/AS -2000 ER Инструкция по эксплуатации
- Electrolux ECH/AS -1500 ER Инструкция по эксплуатации
- Electrolux ECH/AS -1000 ER Инструкция по эксплуатации
- Electrolux ECH/T-2000 E Инструкция по эксплуатации
- Electrolux ECH/T-1500 E Инструкция по эксплуатации
- Electrolux ECH/T-1000 E Инструкция по эксплуатации
- STOUT SVB-0003-000015 Инструкция по эксплуатации
- ORAS 267043 Инструкция по эксплуатации
- Grohe Cube Ceramic 3947400H Инструкция по эксплуатации
- Grohe Cube Ceramic 3938600H Инструкция по эксплуатации
- Euro-lift KCD 19833 Инструкция по эксплуатации
- Condtrol Paint Pro (3-7-051) Инструкция по эксплуатации
- Condtrol Paint Check Инструкция по эксплуатации
- Chicago Pneumatic CP6773- D18D Инструкция по эксплуатации
Скачать
Случайные обсуждения