Home
Главная
Sdmo
Бензиновый Генератор
PERFORM 4500XL
Руководство пользователя Страница: 13

Sdmo PERFORM 4500XL [13/24] Storing the generating set

8. Storing the generating set

If the generating set is not used for a long period of time, it must be stored in accordance with the guidelines given below.

n Open the fuel tap (fig. A - No. 5 & fig. C - No. 1) to “I”.

o Start the generating set and allow it to run till it stops due to lack of fuel.

p Close the fuel tap to “0”.

q While the engine is still hot, change the engine oil (see § Renewing the engine oil).

r Remove the spark plug (fig. F - No. 2) (see § Checking the spark plug) and pour a maximum of 15 ml of engine oil into the cylinder

through the spark plug port before refitting the spark plug.

s Without starting the engine, slowly pull the recoil starter handle (fig. A - No. 8) until you feel a certain resistance.

t Clean the outside of the generating set, apply an anti-rust product on the damaged parts and cover it up with an all-weather dust

cover to protect it from dust.

u Store the generating set in a clean, dry place.

9. Troubleshooting

Problems Probable causes Possible solutions

Engine not

starting

Load connected to the generating set during start-up. Disconnect the load.

Start and Stop control (fig. A - No. 7) “O” or “OFF”. Set the Start and Stop control to “I” or “ON”.

Oil level too low.

Check the oil level and top up if necessary

(see § Checking the oil level).

Fuel tap (fig. A - No. 5) closed. Open the fuel tap.

Fuel level too low. Fill up with fuel (see § Filling with fuel).

Fuel strainer (fig. A - No. 4) blocked.

Clean the fuel strainer (see § Cleaning the fuel

strainer).

Air filter (fig. A - No. 12) blocked. Clean the air filter (see § Cleaning the air filter).

Defective spark plug (fig. F - No. 2).

Check the spark plug (see § Checking the spark plug)

and replace if necessary.

Fuel supply blocked or leaking. Have it checked, repaired or replaced.*

Engine stopped

Oil level too low.

Check the oil level and fill-up if necessary

(see § Checking the oil level).

Fuel level too low. Fill up with fuel (see § Filling with fuel).

Blocked ventilation inlets.

Clean the generating set (see § Cleaning the

generating set).

No electric

current

Circuit breaker (fig. A - No. 9) not actuated. Actuate the circuit breaker.

Defective appliance supply cord. Change the cord.

Defective electrical sockets (fig. A - No. 10). Have it checked, repaired or replaced.*

Defective alternator. Have it checked, repaired or replaced.*

Triggering of

circuit breakers

Device connected or faulty cord. Disconnect the device and the cord.

Overload (see § Capacity of the generating set). Remove the overload.

* Operation(s) to be entrusted to one of our agents.

Sdmo PERFORM 4500XL [13/24] Storing the generating set

Содержание

Похожие устройства