Worx WX183.1 [12/120] Lithium ion cordless drill driver en

Lithium-Ion Cordless Drill Driver EN

1312

LED LIGHT INDICATOR (See Fig. G)

Before operation, the LED light will be activated when the On/Off switch is slightly depressed.

The tool and battery are equipped with a protection system. When the LED Light is quickly flashing

60 seconds and turns off, the system will automatically cut off power to the tool to extend battery

life. The tool will automatically stop during operation if the tool and/or battery are placed under one

of the following conditions:

• Overloaded: The tool is operated in a manner that causes it to draw an abnormally high current. In

WARNING: To turn on the light, press the On/Off switch and make sure the Forward/Reverse

Rotation Control is on right/left position.

PROBLEM SOLUTION

1. WHY DOES THE DRILL NOT TURN ON

WHEN YOU PRESS THE SWITCH?

The Forward and Reverse Switch, which is

on top of the trigger, is positioned in the lock

function. Unlock the Forward and Reverse

Switch putting it into the required rotation

position. Push the trigger and the drill will

Adjustment Ring between the chuck and the

tool body. Position 1 is the lowest torque

(screw driving force) and position 18 is the

highest torque (screw driving force). Position

is for drill operation.

3. I CAN NOT FIT THE BATTERY INTO

THE BATTERY CHARGER. WHY?

The battery can be inserted into the charger only

in one direction. Turn the battery around until it

can be inserted into the slot, the red LED Light

working time. This can be corrected after

several charge and discharge operations by

charging & working with your drill. Heavy

working conditions such as large screws into

hard wood will use up the Battery Pack energy

faster than lighter working conditions. Do not

re-charge your Battery Pack below 0

o

C and

above 30

o

C as this will affect performance.

There are no user serviceable parts in your

power tool. Never use water or chemical

cleaners to clean your power tool. Wipe clean

with a dry cloth. Always store your power

tool in a dry place. Keep the motor ventilation

slots clean. Keep all working controls free

of dust. Occasionally you may see sparks

through the ventilation slots. This is normal

and will not damage your power tool.