Mi Robot Vacuum-Mop SKV4093GL [9/95] Troubleshooting

Battery

Note: If the vacuum-mop is not used for an extended period, turn it off and put it away. To prevent

damage from over-discharging, the vacuum-mop should be recharged at least once every three

months.

The vacuum-mop contains a high-performance lithium-ion baery

pack. Please ensure that it remains well-charged during daily use to

maintain optimal baery performance.

Updating the Firmware

You can update the firmware via the app. Before updating, make sure

System Restarting

If the vacuum-mop stops responding or cannot be turned off, press

and hold down the buon for 6 seconds to forcefully turn it off.

Then press and hold the buon for 3 seconds to turn the

vacuum-mop on.

Restoring Factory Settings

If system restarting does not work, use a pin to press the reset buon

until you hear a voice say "Restoring factory seings". This will reset

the vacuum-mop to its original factory seings.

Fault

Error 1: Please clean and gently tap the bumper.

Solution

If the vacuum-mop encounters an error during operation, the power indicator will blink orange and you will hear a voice alert. To check for a solution,

please refer to the table below.

Part of the vacuum is off the ground. Place the vacuum on level ground and

reactivate it. This error may also occur if the cliff sensor is dirty. To rule out this

possibility, clean the cliff sensor.

Error 4: Please remove the main brush and clean the

bristles and bearings.

A foreign object might be caught in the main brush. Remove the brush and

clean its bristles and bearings.

Error 6: Please check whether any objects are wrapped

around the main wheels, then move the vacuum-mop

to a new location and reactivate it.

A foreign object might be caught in one of the main wheels. Clean the wheels,

then reactivate the vacuum-mop.

A foreign object might be caught in the side brush. Remove the side brush and

clean it.

Troubleshooting

15 16