Grillo Dumper 406 [10/44] Instructions for use
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Grillo Dumper 406 [10/44] Instructions for use

Dumper 406/Translation of the original instructions
TECHNICAL SPECIFICATIONS
ENGINE: Subaru EX17 Hp5, Kohler SH 265 Hp 5,5, with pull-staring system.
CLUTCH: per belt tension.
GEARBOX: gear type in oil bath, 6 speeds: 3 forwards speeds + 3 reverse speeds.
DRIVE: rubber tracks with inner steel links
TRACK BEARING SURFACE: 700 mm.
STEERING: with clutches in oil bath combined with brakes.
CHARGING BODY: mm 1000 x 655 x 200
Openable sides.
Forward tipping system operated by gas springs.
HEIGHT of charging body: 435 mm.
LOAD CAPACITY: 400 kg.
SECURITY DEVICES: automatic handbrake.
SPEED: I km/h 1 – II km/h 2 – III km/h 3,4 – IRM km/h 1 – IIRM km/h 2 – IIIRM km/h 3,4.
OVERALL SIZE: Length 1610 mm.
Width 780 mm.
Height 1100 mm
TRACK EXTERNAL BULK: 650 mm.
WEIGHT: 245 kg.
INSTRUCTIONS FOR USE
PUTTING THE MACHINE INTO SERVICE
Checks before starting:
- Check that the gearbox oil level is correct (fig.4).
- To check the engine oil, unscrew the level cap following the instructions in the engine
manual.
- Check that the air filter is clean (fig.5). Caution! Never blow the cartridge with
compressed air; it must be replaced if seriously clogged.
- Fill the tank with fuel using a funnel complete with very fine filter to trap any dirt.
- Make sure that the gear lever is in neutral position.
- Check the tension of the crawler tracks (fig.6). if they are not taut enough, correct the
adjustment by backing off the lock-nut and tighten the crawler stretcher bolt.
- Check that the steering levers are operating correctly and that the load bed is secure (6,
fig.1).
STARTING THE ENGINE
After making the checks described:
Bring the hand throttle lever (4, fig. 1) to the midway position and engage the choke (10, fig. 1).
Start the engine by pulling the pull-start knob sharply (9, fig. 1).
After the engine has started, disengage the choke (10, fig. 1) and gradually return the throttle close
to the idling position.
Allow the engine to warm up for a few minutes before starting work, and to allow proper running-in
do not force the machine excessively during the first 50 hours of use.
STARTING THE MACHINE
Engage the gear required using the lever (2, fig.1). If the gear does not engage immediately, give
light touches on the clutch (1, fig. 1).
Accelerate the engine using the throttle lever (4, fig.1), and pull the clutch lever (Fig. 7A). The
machine will start. When the lever is released, the machine will stop (Fig. 7B).

Содержание

Похожие устройства

Скачать