Daikin EWWQC13AJYNN Сервис мануал онлайн [119/130] 525392

ESIE07-05 Maintenance

Part 5 – Maintenance 5–7

Filter-driers A replacement of the filter-drier is recommended during scheduled service maintenance of the unit,

any time excessive pressure drop is read across the filter-drier and/or when bubbles occur in the

sightglass with normal subcooling. The maximum recommended pressure drop across the filter-drier

at 75% to 100% circuit loading is 70 kPa. The maximum recommended pressure drop across the

filter-drier at 25% to 50% circuit loading is 35 kPa.

The filter-drier should also be changed if the moisture indicating liquid line sightglass indicates excess

moisture by the wet system color indicators. During the first few months of operation the filter-drier

replacement may be necessary if the pressure drop across the filter-drier exceeds the values listed in

the paragraph above. Any residual particles from the unit heat transfer tubing, compressor and

miscellaneous components are swept by the refrigerant into the liquid line and are caught by the

filter-drier.

To change the filter drier, pump the unit down by moving the ON/OFF compressors switches in “off”

position. Move the ON/OFF switch unit Q0 to the “off” position. Turn off all power to the unit and install

jumpers across the terminals. This takes out the low pressure control. Close the manual liquid line

shutoff valve. Turn the power of the unit back on and restart the unit by moving the ON/OFF switch

unit Q0. The unit will start pumping down past the low pressure setting. When the evaporator pressure

reaches 0.3 bar, move switch Q0 to the “off” position. Remove the jumper.

Close the suction line valve. Remove and replace the filter-drier. Evacuate the lines through the liquid

line manual shutoff valve to remove non condensables that may have entered during filter

replacement. Open the suction line valve. A leak check is recommended before returning the unit to

operation.

Electronic

expansion valve

The EWWQ-AJYNN water cooled chiller is equipped with the most advanced electronic expansion

valve to achieve precise control of refrigerant mass flow. As today’s system requires improved energy

efficiency, tighter temperature control, wider range of operating conditions and incorporate new

features like remote monitoring and diagnostics, the application of electronic expansion valves

becomes mandatory. EWWQ-AJYNN’s electronic expansion valve proposes features that makes it

unique: short opening and closing time, high resolution, positive shut-off function to eliminate use of

additional solenoid valve, highly linear flow capacity, continuous modulation of mass flow without

stress in the refrigerant circuit and corrosion resistance stainless steel body.

Evaporator The evaporator is a direct expansion type with refrigerant inside the copper tubes and water on the

outside. The evaporators are manufactured with carbon steel shells, high efficiency copper tubes and

polypropylene baffles. The copper tubes are roll expanded into carbon steel tube plates.

Condensers Condensers are shell and cleanable, through-tube type (1 pass). The unit has independent

condensers, one per circuit. Each condenser has a carbon steel and seamless, integrally finned high

efficiency copper tubes, roll expanded into heavy carbon steel tube sheets. Water heads are

removable and include vent and drain plugs. Condensers come complete with liquid shut-off valve,

spring loaded relief valve.

Note: The units are furnished with 1 pass condensers as standard (water entering a side and water

leaving the opposite side of the heat exchanger).

ESIE07-05.book Page 7 Friday, December 21, 2007 3:21 PM