Philips PTA02 ⁄ 00 [2/68] Installation

Welcome to the exciting world of 3D TV at

home!

Installation

What’s in the box

- 2x Active 3D glasses

- 2x microber pouch

- a range of 3 nose bridge pieces for each pair

of glasses

- 3D transmitter

- USB device with a TV software update

Prepare the 3D glasses

1 Pull and remove the plastic strip to activate

the battery inside. Or alternatively open the small

battery cover of the 3D glasses and insert the

battery - type CR2032.

2 Mount the nose bridge on the glasses that ts

you best.

Installation

1 Switch off the TV.

2 Connect the 3D transmitter to the 3D con-

nection 3D Out on the back of the TV.

3 Install the 3D transmitter on the top or at

the bottom of the TV. Make sure to point the

transmitter directly to where you sit to watch TV.

The small window in the middle of the glasses

receives the 3D signals from the transmitter.

Update the TV software

To prepare your TV for 3D watching, you must

update the TV software.

1 Switch on the TV.

2 Plug in the USB device in the USB connection

at the side of the TV.

3 The software update will start automatically

and during the update the TV might switch off

and on again. Do not press any key on the

remote control and wait until the message

‘Operation Successful’ appears.

4 Unplug the USB device and switch the TV off

and back on again.

Your TV is ready to watch 3D.

USB

PTA02

292892_Brochure_3D.indd 2 31-05-2010 18:56:28