Home
Главная
Ariston
Стиральная Машина
ALD 128 D
Инструкция по эксплуатации Страница: 26

Ariston ALD 128 D [26/32] Before calling read the following

ARGHERITA

Margherita - Instructions for installation and use

Before calling, read the following

Troubleshooting

In most cases, when your washer-dryer fails to work, the problems arising

can be easily solved without having to call for a technician. Before calling

for assistance, always check these points.

The washer-dryer fails

to start.

Is the plug correctly

inserted into the socket? It

could have been moved whilst

cleaning.

Is there electricity in the

house?

A circuit breaker may have

switched off as a result of too

many electrical appliances

working at the same time. Or

maybe due to a general failure

in your entire area.

Is the washer-dryer door

closed properly?

For safety reasons, the washer-

dryer cannot work if the door

is open or not shut properly.

Is the On/Off button

pressed?

If it is, then a programmed

start has been set.

Is the Start/Reset button

pressed?

If it is, then a programmed

start has been set.

Is the water supply turned

on? For safety reasons, if the

washer-dryer does not load

water, it cannot start a wash

cycle.

RIGHT

WRONG

Turn off the water

supply after use.

This will eliminate

the possibility of

leakage.

Always leave the

appliance door

ajar to avoid bad

odours.

Clean the

appliances

exteriors gently.

To clean the

exteriors and the

rubber parts of

the appliance,

always use a soft

cloth dipped in

warm and soapy

water.

Leave the washer-

dryer plugged in while

cleaning.

Even during mainte-

nance, the appliance

should always be

unplugged.

Use solvents and

aggressive abrasives.

Never use solvents or

abrasives to clean the

external and rubber

parts of the washer-

dryer.

Neglect the detergent

dispenser.

It is removable and

can easily be cleaned

by leaving it under

running water.

Go on holiday without

thinking about her.

Before leaving, always

make sure that the

washer-dryer is

unplugged and that

the water supply is

turned off.

The washer-dryer fails

to fill with water.

Is the hose correctly

connected to the tap?

Is there a water shortage ?

There could be work in

progress in your building or

street.

Is there sufficient water

pressure? The autoclave may

be malfunctioning.

Is the tap filter clean? If the

water is very calcareous, or if

work has recently been carried

out on the water piping, the tap

filter could be clogged with

particles and debris.

Is the rubber hose kinked?

The tract of the rubber hose

bringing water to washer-dryer

must be as straight as possible.

Make sure it is not squashed

or kinked.

The washer-dryer

continuously fills and

drains water.

Is the drain hose

positioned too low? It must

be installed at a height ranging

from 60 to 100 cm.

Is the end of the hose

immersed in water?

Does the wall drainage

system have a breather

pipe? If the problem persists

even after these checks, turn

the water supply off the

machine and call for

assistance.

If you live on an upper floor of

your building, there may be a

problem with your drain trap.

To solve this problem, a special

valve must be installed.

Simple: with the new Ariston technology, you need less than

half of it, to get good results on twice as much!

This is why you cannot see the water through the door:

because there is little, very little of it, to respect the

environment yet without renouncing maximum cleanliness.

And, on top of that, you are also saving electricity.

But where did all the water go?

Содержание

Похожие устройства

ARGHERITA Troubleshooting Before calling read the following In most cases when your washer dryer fails to work theproblems arising can be easily solved without having to call for a technician Before calling for assistance always check these points The washer dryer to start fails Is the plug correctly inserted into the socket It could have been moved whilst cleaning Is there electricity in the house A circuit breaker may have switched off as a result of too many electrical appliances working at the same time Or maybe due to a general failure in your entire area Is the w asher dryer closed properly door dryer cannot work if the door is open or not shut properly Is the pressed On Off If it is then start has been set a button programmed Is the Start Reset pressed If it is then start has been set a But where did all the water go Simple witli tlie new Aristontechnologj you need less than halfofit to get good resultson twice as much This is why you cannot see the water through the door because there is little very little ofit to respect the environment yet without renouncing maximum cleanliness And on top of that you are also saying electricity button programmed Is the w ater supply turned on For safety reasons if the w asher dryer does not load water it cannot start a wrash cycle For safety reasons the washer The washer dryer continuously fills and drains water The washer dryer fails to fill with water RIGHT WRONG Turn off the water supply after use This will eliminate the possibility of leakage Always leave the appliance door ajar to avoid bad odours Clean the appliance s exteriors gently To clean the exteriors and the rubber parts of the appliance always use a soft cloth dipped in warm and soapy water Leave the washer dryer plugged in while cleaning Even during mainte nance the appliance should always be unplugged Use solvents and aggressive abrasives Never use solvents or abrasives to clean the external and rubber parts of the washer dryer Neglect the detergent dispenser It is removable and can easily be cleaned by leaving it under running water Go on holiday without thinking about her Before leaving always make sure that the washer dryer is unplugged and that the water supply is turned off 23 Margherita instructions for installation and use Is the hose correctly connected to the tap There could be work progress in your building street in or Is there sufficient water pressure The autoclave may be malfunctioning Is the tap filter clean If the water is very calcareous or if w ork has recently been carried out on the water piping the tap filter could be clogged with particles and debris Is the rubber hose kinked The tract of the rubber hose bringing water to washer dryer must be as straightas possible Make sure it is not squashed or kinked Is the drain positioned too low hose Itmust be installed at a height ranging from 60 to 100 cm Is there a w ater shortage Is the end of the hose immersed in w ater Does the wall drainage system have a breather pipe If the problem persists even after these checks turn the water supply off the machine and call for assistance If you live on an upper floor of your building there may be a problem with your drain trap To solve tills problem a qjedal valve must be installed