AXIOMET AX-904 [5/10] Addition of area under area mode

• Press the RM key to recall previous measurement for the addition (displayed on the bottom of the display),

and at the same time, the “M+” icon disappears and the stored memories will be automatically eliminated;

• Press+/= key, the sum is shown on the lower portion of the screen.

4.5. Area

• Press MODE key to enter area mode, and the ” ”will appear on the display for calculation of a room area;

• The length character “L” on the display will blink showing the length measurement you will be firstly taking.

Press READ key to take length measurement that is displayed on upper portion of the screen. (Step 1);

• The width character “W” on the display will blink showing the next measurement to take. Press READ key

to take width measurement that is displayed on upper portion of the screen (Step 2);

• Then the area is automatically displayed on the lower portion of the screen;

• Press the READ key again will toggle back and forth between the length and width measurement on the upper

portion of the screen;

• Press MODE key to clear the data on the portion of the screen, then can begin the new calculation of area.

• To choose measurement mode, press MODE key again.

Tips

Press the MODE key one by one will toggle back and forth between the length, area, volume and length mea-

surement. If there are datum on the display, first pressing the MODE key will clear the current datum, and the

mode will be invariable.

4.6. Addition of area under area mode

• Press the M key to save the calculated area of first time measurement, at the same time, the “M+” icon appears

on the screen;

• Press MODE key to clear the current displayed data, then can begin the second time measurement and

computation (follow step 1 and step 2 under the area section);

• After getting the desired area of the second time computation, press +/= to enter the addition mode. A “+”

icon would appear on LCD.

• Press RM key to recall the first calculated area for the addition. The “M+” icon will disappear and the stored

memory will be automatically cleared;

• Press +/= key, the sum of both areas is shown on the lower portion of the screen;

• Repeat the steps above to keep adding the measured area.

4.7. Volume

• Press MODE key to enter volume mode, and the ” ”will appear on the display for calculation of a room

volume;

• The length character “L” on the screen will blink showing length measurement will be taking. Press READ

key to take length measurement, the result will be displayed on upper portion of screen. (Step 1)

• The width character “W” on the screen will blink showing the next measurement to take. Press READ key to

take width measurement, the result will be displayed on upper portion of screen. (Step 2);