Home
Главная
Teka
Варочная Поверхность
VT TC 2P.1
Инструкция по эксплуатации Страница: 16

Teka VT TC 2P.1 [16/16] Start of operation

Instructions for assembly

Electrical connection

• The electrical connection must be carried out by a qualified

electrician who is authorised to carry out such work!

• Statutory regulations and the connection specifications issued

by the local power supply company must be strictly observed.

• When connecting the appliance it must be ensured that there

is a device which makes it possible to disconnect it from the

mains at all poles with a contact opening width of at least

3 mm. Line-protecting switches, fuses or contactors are

suitable cut-out devices. When connecting and repairing the

appliance disconnect it from the electricity supply with one of

these devices.

• The earth wire must be sufficiently long so that if the strain

relief fails, the live wires of the connecting cable are subjected

to tension before the earth wire.

• Any superfluous cable must be removed from the installation

area beneath the appliance.

• Make sure that the local mains voltage is the same as the

voltage on the rating label.

• The hob has been fitted with a temperature-resistant

connection cable in the factory.

• The connection cable must be at least H05 RR-F.

• If the excess cable of this appliance is damaged, it has to be

replaced by the manufacturer, the Customer Service of the

manufacturer or by another qualified person to avoid danger.

• Full protection against accidental contact must be ensured on

installation.

• Attention: Incorrect connection may result in the power

electronics unit being destroyed.

Power supply

Mains voltage: 220 - 240V~, 50-60 Hz

Component rated voltage: 220 - 240V

Start of operation

Once the hob has been installed and the power supply has been

provided (mains connected) an automatic test of the controls will

be carried out and information for Customer Service will be

indicated.

Briefly wipe over the surface of the hob with a sponge and soapy

water and then dry with a clean cloth.

Important

Inspection (quality control) of the hob during production

may result in information still being contained in the

memory. This could mean that an H lights up in the cooking

level display for a maximum of 60 minutes once the

appliance has been connected to the mains power supply.

This is of no significance to the user.

Technical data

Dimensions

Hob

Height/ Width/ Depth mm 40 x 294 x 519

Cooking zones

Rear Ø cm (kW)

Front Ø cm (kW)

18/12 (1.7/ 0.7)

14 (1.2)

Hob, total kW 2.9

Dimensions

Hob

Height/ Width/ Depth mm 40 x 294 x 519

Cooking zone

18.5 x 30.5

1.4

Hob, total kW 1.4

Teka VT TC 2P.1 [16/16] Start of operation

Содержание

Похожие устройства