Gorenje GMS640E1 [41/52] Installation

INSTALLATION

IMPORTANT INSTALLATION SPECIFICATIONS

The installer should note that the appliance that side walls should be no higher than the hot plate itself.

Furthermore, the rear wall, the surfaces surrounding and adjacent to the appliance must be able to

withstand an overtemperature of 65K.

The adhesive used to stick the plastic laminate to the cabinet must be able to withstand a temperature of

not less than 150° C otherwise the laminate could come unstuck.

The appliance must be installed in compliance with the provisions in force.

This appliance is not connected to a device able to dispose of the combustion fumes. It must therefore be

connected in compliance with the above mentioned installation standards. Particular care should be paid

to the following provisions governing ventilation and aeration.

5) ROOM VENTILATION

It is essential to ensure that the room in which the appliance is installed is permanently ventilated in order to

allow the appliance itself to operate correctly. the necessary amount of air is that required for regular gas

combustion and ventilation of the relative room, the volume of which must not be less than 20 m

. Air must

naturally flow through permanent openings in the walls of the room in question. These openings must vent

the fumes outdoors and their section must be at least 100 cm

(see fig. 3). Construction of the openings must

ensure that the openings themselves may never be blocked. Indirect ventilation by air drawn from an

adjacent room is also permitted, in strict compliance with the provisions in force.

CAUTION: if the burners of the cooking top are without safety thermocouple, the ventilation outlet must

have a minimum 200 cm² section.

6) LOCATION AND AERATION

Gas cooking appliances must always dispose of their combustion fumes through hoods. These must be

connected to flues, chimneys or straight outside. If it is not possible to install a hood, an electric fan can be

installed on a window or on a wall facing outside (see fig. 4). This must be activated at the same time as the

appliance (see fig. 5), so long as the specifications in the provisions in force are strictly complied with.