Icom IC-F310 [8/20] Panel description
![Icom IC-F310 [8/20] Panel description](/views2/1074525/page8/bg8.png)
1
PANEL DESCRIPTION
5
TRUNKING GROUP SWITCH
Push to select the trunking group.
VOICE SCRAMBLER SWITCH
• Push and hold to turn the voice scrambler function ON.
• Push to turn the voice scrambler function OFF.
NOTE:
•Optional UT-109 (#02) or UT-110 (#02) VOICE
SCRAMBLER UNIT is required.
•IC-F320(420)S’s with serial numbers above
50000 are compatible with voice scrambler
units.
•Contact your dealer for details.
PRODUCT INFORMATION
■ This IC-F310/320(F410/420)S’s with se-
rial numbers above 50000 are compati-
ble with the optional UT-109/ UT-110
voice scrambler units.
UT-109: Non-rolling type. 32 code num-
bers are available.
UT-110: Rolling type. Provides higher
communication security. 1020 (4
groups × 255) code numbers are
available.
■ This transceiver requires version #02
scrambler units, do not install version
#01, as they are not compatible.
■ UT-109 and UT-110 require some PC
board modifications. Please refer to the
additional installation manual.
Please contact your dealer for details.
(See pgs. 5, 8, 11, 18)
GRP
SCRM
Содержание
- If320s if310s 1
- If410s if420s 1
- Instruction manual 1
- Uhf transceiver 1
- Vhf transceiver 1
- Cautions important 2
- Explicit definitions 2
- R warning neve 2
- Read all instruction 2
- Save this instruction manual 2
- Be careful 3
- Connection and maintenance 9 12 3
- Important i explicit definitions i cautions i table of contents ii 1 panel description 1 5 3
- Operating the transceiver without running the vehi cle s engine the vehicle s battery will quickly run out if the transceiver is in transmission while the vehicle s engine is off 3
- Operation 6 8 3
- Optional smartrunk ii operation 13 15 3
- Options 16 3
- Placing the transceiver against walls this will ob struct heat dissipation 3
- Placing the transceiver in excessively dusty envi ronments 3
- Table of contents 3
- The transceiver will become hot when operating continuously for long periods 3
- The use of chemical agents such as benzine or al cohol when cleaning as they damage the transceiver sur faces 3
- Use or place the transceiver in areas with tem peratures below 30 c or above 60 c or in areas subject to direct sunlight such as the dashboard 3
- I front panel 4
- Panel description 4
- I function led 5
- Panel description 5
- I programmable function keys 6
- Panel description 6
- Panel description 7
- Panel description 8
- Product information 8
- 5 1 6 2 7 3 8 4 9 9
- I channel selection 9
- I turning power on 9
- Operation 9
- D transmitting notes 10
- I receiving and transmitting 10
- Important 10
- Operation 10
- D dtmf transmission 11
- D entering the user set mode 11
- D scrambler function 11
- I user set mode 11
- Operation 11
- Connection and maintenance 12
- I rear panel and connection 12
- Connection and maintenance 13
- I supplied accessories 13
- Connection and maintenance 14
- I mounting the transceiver 14
- I optional ut 96 ut 105 ut 109 and ut 110 installation 14
- A key element in the performance of any communication sys tem is an antenna ask your dealer about antennas and the best places to mount them 15
- Avoid the use of solvents such as benzene or al cohol as they may damage transceiver surfaces 15
- Connection and maintenance 15
- I antenna 15
- I cleaning 15
- I fuse replacement 15
- I optional opc 617 installation 15
- If the transceiver becomes dusty or dirty wipe it clean with a dry soft cloth 15
- Install the opc 617 as shown below 15
- Two fuses are installed in the supplied dc power cable if a fuse blows or the transceiver stops functioning track down the source of the problem if possible and replace the dam aged fuse with a new rated one 15
- D calling another local system subscriber 16
- D placing a telephone call 16
- D receiving a call 16
- I smartrunk ii and conventional modes 16
- I smartrunk ii operation 16
- Optional smartrunk ii operation 16
- D emergency call 17
- D last number redial 17
- D memory speed dialing 17
- D programming memory speed dial 17
- D ptt dispatch operation 17
- D system busy indication 17
- D terminating a call 17
- D turbo speedial 17
- Optional smartrunk ii operation 17
- D clear channel alerting 18
- Optional smartrunk ii operation 18
- Options 19
- 9 16 kamihigashi hirano ku osaka 547 0002 japan 20
Похожие устройства
- Ardo KA 540 G6 Инструкция по эксплуатации
- Fujifilm F XF60MMF2.4R Macro Инструкция по эксплуатации
- Icom IC-F320 Инструкция по эксплуатации
- Ardo KC 640 G6 Инструкция по эксплуатации
- Sony SAL 1650 Инструкция по эксплуатации
- Icom IC-F410 Инструкция по эксплуатации
- Ardo TLE 66V4 EF Инструкция по эксплуатации
- Tokina AT-X 11-16 F/2.8 Инструкция по эксплуатации
- Icom IC-F420 Инструкция по эксплуатации
- Ardo C 6604 EB Инструкция по эксплуатации
- Tokina AT-X 16-28 F/2.8 ProFX Инструкция по эксплуатации
- Toshiba 22L1353 Инструкция по эксплуатации
- Ardo A 5604 EB Инструкция по эксплуатации
- Tokina AT-X M100 F/2.8 Macro Инструкция по эксплуатации
- Toshiba 32L6353 Инструкция по эксплуатации
- Ardo A 5504 EB Инструкция по эксплуатации
- Bosch WLX24364OE Инструкция по эксплуатации
- Toshiba 50L2353 Инструкция по эксплуатации
- Ardo KTLE 66V4 EF Инструкция по эксплуатации
- Toshiba 22L1354 Инструкция по эксплуатации