Marta MT-1088 Blue Sapphire [6/11] Gbr user manual

6

GBR USER MANUAL

IMPORTANT SAFEGUARDS

Read this manual carefully before using the appliance and save it for future reference.

 When using electrical appliances, basic precautions should always be followed, including the following:

 Read all instructions thoroughly before using the appliance.

 Do not use or store the unit in damp and moist areas where it may come in contact with water.

 Keep out of the reach of children.

 Do not use the kettle if it has been damaged or modified or appears to have malfunctioned in any way.

 Do not operate the kettle with a damaged or incorrect cord or plug.

 This kettle is intended for heating water only. Use of any other liquids or food may damage the interior and void warranty.

 Do not allow the cord to hang over the edge of the table or counter, or contact any hot surfaces.

 This kettle is designed for Household use only! Do not use outdoors.

 When not in use and before cleaning, disconnect the kettle from the outlet. Allow the kettle to cool completely before attempting to clean.

 Do not remove the lid during the heating cycle. Scalding may occur.

 Do not operate the kettle without water. If the unit overheats, please allow the unit to cool for at least 15 minutes.

 Do not fill above the MAX line; this may cause water to overflow, which may cause scalding.

 Steam may damage walls or cabinets, during use turn the spout away from walls toward an open space; use heat resistive pads under the kettle to prevent damage to wood finishes.

 Do not wash under direct running water as this will damage the control panel. Clean with a soft moist cloth.

 Do no use or store the unit in direct sunlight or near other heat sources (oven, stove, etc.).

 The kettle may have difficulty bringing water to boil when used in high altitudes or extreme cold conditions.

 Do not disassemble or attempt to repair on your own.

PLEASE SAVE THiS INSTRUCTION!

BEFORE FIRST USE

Remove all packaging materials.

Fill kettle to the MAX line and bring to a boil. When the unit completes the boiling cycle, discard the water - repeat the process 2 to 3 times. This will remove any dust or residue remaining from the

manufacturing process.