Metabo BasicAir 250 [12/109] Safety devices

Metabo BasicAir 250 [12/109] Safety devices
ENGLISH
12
4.4 Safety devices
Safety valve
BasicAir 250/350
PowerAir 350
The spring safety valve (36) is incorpo-
rated into the pressure switch unit. The
sa
fety valve opens if the max. permissi-
ble pressure is exceeded.
5.1 Prior to initial operation
Installing the wheels
Install wheels as illustrated.
Insert dip stick
1. Remove the plug (38) from the
crankcase.
2. Substitute the plug (37) with the dip
stick supplied.
The plug prevents oil from leaking from
the
crankcase during shipping. Keep
plug for future use.
Assembling the air filter
1. Remove the plug from the air inlet
of the compressor pump housing
(39). Keep plug for future use.
BasicAir 250
BasicAir 350 and PowerAir 350
2. Screw air filter (40) supplied on air
intake.
Checking the condensate outlet
Make sure the condensate outlet is
closed (41).
5.2 Installation
The device's installation location must
meet the following requirements:
dry, cool, protected from frost
firm, horizontal and level surface.
ADanger!
Severe accidents may arise due to in-
correct installation.
Secure the device against rolling
away, tipping over and slipping.
Do not pull the device by the hose
or power supply cable. Transport
the machine by the handle only.
Safety devices and operating ele-
ments must be easily accessible at
all times.
5.3 Mains connection
BDanger! High voltage
Operate machine in dry environment
on
ly. Operate machine only on a power
source complying with the following re-
quirements:
outlets properly installed, earthed
an
d tested;
fuse protection in accordance with
the techni
cal specifications.
Make sure that the mains cable is out
of the way so that it does not interfere
with the work and cannot be damaged.
Always check to see that the machine
is switched OFF
before plugging in.
Protect mains cable from heat, aggres-
sive liquids and sharp edges.
26 Motor speed / nominal output
powe
r
27 CE-mark – This machine con-
forms to the EC Directives as per
Decla
ration of Conformity
28 Date of manufacture
29 Suction capacity
30 Filling rate
31 Speed (compressor pump)
32 No. of cylinders
33 Maximum pressure
34 Volume of pressure vessel
35 Waste disposal symbol – Machine
can be di
sposed of by returning it
to the manufacturer
5. Operation
36
36
37 38
39 40
39
40
41

Содержание