M-Audio Delta 1010 — руководство пользователя по аудиовыходам Delta 1010 [13/45]

13Delta 1010 User Guide

Audio Outputs:

The following list should help you associate the output names displayed by your

software with Delta 1010’s corresponding physical outputs:

Display Name Corresponding Outputs

Delta 1010 1/2 Analog Outputs 1/2

Delta 1010 3/4 Analog Outputs 3/4

Delta 1010 5/6 Analog Outputs 5/6

Delta 1010 7/8 Analog Outputs 7/8

Delta 1010 9/10 S/PDIF Output

NOTE: There may be slight variations in the naming of outputs when using

certain audio applications. For example, an output pair may be labeled “ASIO

1-2” instead of “Delta 1010 1/2.” Furthermore, some programs may break down

the outputs listed above into individual “left” and “right” mono channels. In this

case, the software may display the outputs as “Left Delta 1010 1,” “Right Delta

1010 2,” etc. Refer to your application’s user guide to learn more about how

outputs are labeled.

When using the Patchbay/Router’s default settings, signals from your audio application

will be sent directly to Delta 1010’s corresponding physical outputs. Keep in mind that

the Patchbay/Router allows you to modify the output routing of the interface. In other

words, if the Patchbay/Router default settings have been altered, selecting an output

port by name in your audio software may not send audio to the corresponding hardware

output. To learn more about the Patchbay/Router, see the “Patchbay/Router Tab”

section in the Control Panel chapter of this guide.

NOTE: Some audio applications may make certain Control Panel settings

unavailable while the application is open. If your software does this, close the

audio application before changing your Control Panel setting. Alternatively,

certain DAW applications allow you to launch the Control Panel or change

Control Panel settings from within the application itself. This process varies

from program to program, but it is usually done through the “conﬁguration” or

“audio setup” page of your software.