M-Audio Delta 1010 [18/45] Hardware settings tab

Delta 1010 User Guide18

< S/PDIF In: This input corresponds to the S/PDIF input.

< S/PDIF In (L/R Rev.): This corresponds to the S/PDIF input but swaps the left

and right channels.

< H/W In 1/2 through 7/8: These inputs correspond to the hardware analog

inputs of the Delta 1010 interface.

TIP: To restore the Router/Patchbay to its default settings, select the topmost radio

button in each column.

Hardware Settings Tab

The Hardware Settings tab gives you control over a variety of features of Delta 1010.

These features are grouped into the following sections:

NOTE: Some audio applications may make certain Control Panel settings

unavailable while the application is open. In this case, you will need to adjust these

settings through the audio application itself. This process varies from program to

program, but it is usually done through the application’s “Conﬁguration” or “Audio

Settings” menu. Refer to your audio software’s documentation to learn how to do

this.

< MASTER CLOCK: This section allows you to select the source of the interface’s

master clock. Delta 1010 allows you to select among the following three

sources: Internal Xtal, S/PDIF In, and Word Clock.

If you are using your Delta 1010 by itself, this parameter must be set to “Internal

Xtal” for the interface to work properly. This setting uses Delta 1010’s internal

crystal oscillator as the source of the master clock.

If you have connected a S/PDIF device to your Delta 1010’s S/PDIF input, set

S/PDIF as the source of Delta 1010’s master clock and make sure that the

external S/PDIF device is conﬁgured to provide the master clock signal. This will

slave Delta 1010 to the external device’s clock and allow S/PDIF signals to enter

the interface.