Home
Главная
Haier
HWD8040BW1
Инструкция по эксплуатации Страница: 5

Haier HWD8040BW1 — установка и подготовка к эксплуатации стиральной машины [5/14]

Haier HWD8040BW1 [5/14] General information and tips

Installation

Preparation

Remove all packaging material including polystyrene

base. While opening the package , water drops may be

seen on plastic bag and porthol e. This is normal as a

result from water tests and quality control in the factory.

Inlet hose

1. Connect inlet hose to the machine of water inlet valve.

2. Connect inlet hose to a water tap.

3. Tighten inlet hose connections and turn on water

supply. Check for any water leaks. Stop all water

leaks before continuing with in stallation.

Warning!

Appliance is only qualiﬁed for cold water supply!

Drain hose

Drainage could be installed in dif ferent ways.

of drain hose has to reach between

80-100 cm.

If possible always keep drain hose ﬁxed to the clip at

the back of the appliance.

Fix the bracket securely to avoid dropping due to oper-

ational movements.

1. Drain hose to sink

2. Drain hose to sink siphon

Connection has to be securely sealed and ﬁxed to corr-

esponding adapter above the siphoning part!

3. Adjust all feets to achieve a complete level

position.This will minimize vibrations and noise

during use. It will also reduce wear and tear. We

recommend to use a spirit level for adjustment. Floor

should be as stable and ﬂat as possible.

80 - 100 cm

The drain hose should not be submerged in water and

should be securely ﬁxed and leak-free. If the drain hose

is placed on the ground or if the pipe is at a height of

less than 80 cm, the washing machine will continuously

drain while being ﬁlled (self-siphoning).

Warning!

Note: Packaging disposal:

Keep all packaging material out of children’s reach and

dispose them in an e nvironmentally friendly manner.

Use the drain hose bracket to keep drain hose end

retained and out of any water level.

Regardless

OPTIONAL: Install noise reduction pads

1.When opening the shrink package,you will ﬁnd four

noise reduction pads.These are used for reducing

noise.(Fig. 1)

2. Lay the washing machine down to its side, port-

hole pointing upwards, bottom side towards op-

Take out the noise reduction pads and remove the

double-sided adhesive protective ﬁlm；Paste around

the bottom；The noise reduction pads under the

washing machine cabinet as shown in Fig3.(two

longer pads in position 1 and 3, two shorter pads in

position 2 and 4). Finally set the machine upright again.

erator.（Fig.2）

Removing the transportation bolts

The transportation bolts are designed for clamping

antivibration components inside the appliance during

transportation.

1. Remove all 4 bolts.

Keep the transportation bolts in a safe place for later

use. If the machine is to be moved to another location,

replace transportation bolts to prevent damage.

2. Fill the transportation bolt holes with blanking plugs.

General information and tips:

Haier HWD8040BW1 — установка и подготовка к эксплуатации стиральной машины [5/14]

Содержание

Похожие устройства