Haier HWM70-FD10829 [26/29] Installation

9-Installation

Following connections are possible:

9.6.1 Drain hose to sink

▶ Hang the drain hose with the U-support over the

edge of a sink with adequate size (Fig. 9-6.1).

▶ Protect the U-support suciently against slip-

ping.

9.6.2 Drain hose to waste water connection

▶ The internal diameter of the stand pipe with

vent-hole must be minimum 40 mm.

▶ Put the drain hose for approx. 80 mm in the

wastewater pipe.

▶ Attach the U-support and secure it suciently

(Fig. 9-6.2).

9-6.2 9-6.1

9.6 Drain Water Connection

Fix the water drain hose properly to the piping. The hose has to reach at one point a height

between 80 and 100 cm above the appliance bottom line! If possible keep always drain

hose xed to the clip at the appliance back.

WARNING!

▶ Use only the supplied hose set for the connection.

▶ Never reuse old hose sets!

▶ Only connect to cold water supply.

▶ Before connection, check whether the water is clean and clear.

CAUTION!

▶ The drain hose should not be submerged in water and should be securely xed and

leak-free. If the drain hose is placed on the ground or if the pipe is at a height of less

than 80 cm, the washing machine will continuously drain while being lled (self-si-

phoning).

▶ Drain hose is not to be extended. If necessary contact after sales service.

9.6.3 Drain hose to sink connection

▶ The junction must lie above the siphon

▶ A spigot connection is usually closed by a pad (A).

That must be removed to prevent any disfunc-

tion (Fig. 9-6.3).

▶ Secure the drain hose with a clamp.

9-6.3