Moser Li+Pro Mini [11/74] English

ENGLISH

Attaching/removing the attachment comb

· Slide the attachment comb on to the blade set in the direction of the arrow until it reaches the

limit stop (Fig. 4a).

· The attachment comb can be removed by pushing it in the direction of the arrow (Fig. 4b).

Cleaning and Care

· Do not immerse the appliance in water!

· After every usage, remove the attachment comb and fold aside the blade set (Fig. 6a). Use

the cleaning brush to remove any cut hairs from the blade set and from the housing opening.

· The charging contacts on the appliance and charging stand should always be kept clean.

· Only wipe the appliance with a soft cloth, which may be dampened slightly. Do not use sol-

vents or abrasives!

· The blade set can be cleaned with hygienic spray, order no. 4005-7051.

Do not use any other cleaning agents.

· For a long-lasting, good cutting performance, it is important to oil the blade set frequently

(Fig. 8). Use only blade set oil for this purpose, order no. 1854-7935 (200 ml).

· Blade set oil and hygienic spray is available from your dealer or our Service Centre.

· If the cutting performance deteriorates after long use despite regular cleaning and oiling, the

blade set should be replaced.

Changing the blade set

· Switch off the appliance using the on/off switch (Fig. 2).

· The blade set can be removed by sliding it away from the housing in the direction of the

arrow (Fig. 6a).

· Replace the blade set by hooking it into the housing and pressing it down until it clicks into

position in the housing (Fig. 6b).

Disposal in EU countries

Do not dispose of the appliance with domestic refuse. As part of the EU Directive gov-

erning the disposal of electrical and electronic equipment, the appliance is accepted

free of charge by local waste collection points or recycling centres. Correct disposal

will ensure environmental protection and prevent any potentially harmful impacts on

people and the environment.

Disposal in non-EU countries

· Please dispose of the appliance at the end of its service life in an environmentally friendly

manner.

· Disconnect the plug-in transformer from the mains power supply and switch on the appliance

to discharge the battery completely.

· Remove the blade set (Fig. 6a) and use a screwdriver to remove the screws on the housing

(Fig. 9). Remove the complete drive unit with circuit board (Fig. 10) and remove the plate

from the circuit board (Fig. 11).

· Pull the batteries off the circuit board. If necessary, use a screwdriver to pry them off

(Fig. 12).

· Take the battery to an appropriate collection point.

· Once the battery has been removed, the appliance may no longer be connected to the

mains!