Karcher K 5.86 M Plus EU [11/168] Commissioning and operation

Karcher K 5.86 M Plus EU [11/168] Commissioning and operation
English 11
Definition of abbreviations used:
HP = High pressure
DT = Detergent
When unpacking the product, make sure that
no accessories are missing and that none of
the package contents have been damaged. If
you detect any transport damages please
contact your dealer.
Illustrations on Page 2
1 ON/OFF switch for appliance
2 Power cable with plug
3 HP outlet
4 HP hose
5 Trigger gun with safety catch
6 Connection for water supply with filter
7 Coupling element for water connection
8DT tank
9 DT suction hose with filter
10 DT metering regulator
11 Accessory mount, trigger gun
12 Accessory mount, HP hose
13 Accessory mount, spray lance
14 Transport handle
15 Spray lance with pressure regulation
(Vario Power)
16 Spray lance with dirt blaster
When the appliance is delivered, the HP hose
and trigger gun are not attached, this pre-
vents buckling. Please mount these before
using the appliance for the first time.
Î Push out the safety clip in the trigger gun
using e.g. a small screwdriver.
Î Join HP hose and trigger gun together.
Î Push clip in until it engages and check that
it is securely fastened by pulling on the HP
hose.
Î Remove cable tie and unroll HP hose
For connection values, see type plate/techni-
cal data.
Observe regulations of water supplier.
Î Use a fibre-reinforced hose (not included)
with a standard coupling: - Minimum diam-
eter, 1/2 inches (13 mm). - Minimum
length, 7.5 m.
Î Screw the coupling unit (supplied) to the
water connection on the appliance.
Î Push the water supply hose onto the cou-
pling unit, then connect it to the tap.
Caution
Never operate the high-pressure cleaner
when the tap is turned off as dry running will
damage the HP pump.
If the water supply is not clean, the Kärcher
water filter must be used (special accessory -
order No. 4.730-059).
According to the applicable regula-
tions, the appliance must never be
used on the drinking water net with-
out a system separator. Use a suita-
ble system separator manufactured by
Kärcher; or, as an alternative, a system sepa-
rator as per EN 12729 Type BA.
When fitted with the appropriate accessories,
this high-pressure cleaner can draw in surface
water, e.g. from water butts or ponds (max.
suction height 0.5 m).
Î Use the Kärcher water filter to protect the
HP pump and accessories (special acces-
sories, order no. 4.730-059). This filter re-
moves dirt from incoming water.
Î As the standard coupling system is not
suitable for use in suction mode, the
Kärcher suction hose with integrated filter
should be used instead (special accesso-
ry, order no. 4.440-238) and suspended
inside the water butt.
Î Remove air from appliance before opera-
tion: Switch on the appliance when the HP
hose is not connected and run it until the
water which discharges from the HP outlet
is free of bubbles. Switch off appliance
and connect HP hose.
Note: Fill suction hose with water before
use, this will help ventilate the pump of air.
Î Screw HP hose on to HP outlet on appli-
ance.
Commissioning and operation
Description of the Appliance
Initial start-up
Water supply
Water supply from mains
Drawing in water from open reservoirs
Start up

Содержание

Скачать
Случайные обсуждения

Ответы 0

Как заменить предохранитель
3 года назад