Sanitas SMG115 [14/36] Cleaning

Setting the intensity level

Note: The intensity can only be set if the electrodes have skin contact.

You have to set the intensity level at the beginning of each training session. Press the intensity

selection key m to increase the intensity and intensity selection key .. to reduce the intensity.

Depending on the intensity, you will ﬁrstly feel tingling and later a muscle contraction. Only set

the intensity as high as still feels pleasant for you.

Stopping pulses that are too strong

You can reduce the intensity at any time or switch off the device again by pressing the On/Off

key (~ 2 seconds). If you pull the belt away from your stomach so the skin contact in the

electrode region is interrupted, the intensity level automatically returns to zero. If contact is

reestablished with the skin no more voltage is applied.

Avoiding unwanted pulse changes

To avoid inadvertently increasing the intensity of a training session, simply switch on the key

lock. Press the program selection key for around 3 seconds for this purpose. An acoustic

signal sounds and the “

” symbol appears on the display. To deactivate the key lock press

the key once more.

Reacting to unpleasant sensations

If you feel prickling or itching on your skin even if, at this stage, you only notice a tingling and

not muscle contraction, you should switch off the device and proceed as follows:

– Check whether the electrodes are OK or if they are defective.

–

Check whether the round cover over the electrode connections is still in place.

– Take the belt off and completely moisten it again.

– Ensure good skin contact and good moistening the next time the belt is applied.

Taking a break during the training session

If you wish to take a break during a program, brieﬂy press the Pause key. An acoustic signal

sounds and the pause symbol “II” symbol appears on the display. By pressing the key again

you can continue the program.

Reading off the number of training sessions

You can read off the number of your training sessions on the display. The numbers after the

program denote how often you have already fully completed a program. These numbers are

stored until there is a battery change.

6. Cleaning

– Remove the batteries from the device each time you clean it.

– Clean the device with a slightly moistened cloth. In case of more extreme soiling you

can also moisten the cloth with mild soapy water.

– Never drop the device.

– Ensure that no water penetrates into the device. If this should ever happen then only

use the device once it is completely dry.

– Do not use any chemical cleaners or abrasive agents for cleaning.

– Once you have removed the device (operating unit), you can wash the belt in luke warm

water. Use mild soapy water or a liquid detergent for this purpose. Do not use bleaches.

– The belt is unsuitable for machine washing.