Denzel DT 33 [12/95] Denzel

Содержание

Похожие устройства

DEnZEL GASOLINE TRIMMER 6 Immediately after starting the engine slightly push the throttle control lever and release it The engine should go to idle mode Move the air flap control lever to the lower position open 7 Warm up the engine for 30 60 seconds and start work 8 If the engine does not start it is possible that you missed the first flash and the candle was flooded with fuel In this case you must perform the following steps 9 Ignition switch set to OFF 0 Стоп Remove the cap from the spark plug by pulling it towards you along the axis of the spark plug Remove and dry the spark plug By pressing the gas trigger pull the starter handle a few times to ventilate the engine and remove excess fuel from it Reinstall the candle Without closing the air damper repeat the start up procedure Starting a warm engine When starting a warmed up engine as a rule no fuel pumping is required using a primer and closing the air damper The launch is carried out as follows 1 Turn on the ignition using the switch located on the control handle fig 10 2 Pressing the safety lever push the throttle lever throttle lever and lock it in the depressed state with the latch fig 10 3 Gently pull the starter handle until it snaps into the mechanism and vigorously pull the cord another 50 60 cm To avoid damaging the starter case do not throw the starter handle gently return it to its original position Repeat these steps 2 3 times the engine should start 4 Immediately after starting the engine lightly press the throttle control lever and release it The engine should go to idle mode Engine stop To stop the engine release the gas trigger put the engine at idle and let it run for 15 20 seconds Then turn the ignition switch to the stop position A ATTENTION Idle mode is necessary in order to reduce the temperature inside the engine Immediately stopping the engine can lead to a sharp rise in the temperature inside the engine and its failure WORK RULES A ATTENTION All trimmer work should be done in full gas mode Do not use a trimmer without a properly installed guard During operation monitor the health and sharpness of the cord trimming knife With the cover removed or defective you will not be able to control the length of the trimmer reel cord and accordingly the load on the motor and drive shaft A A ATTENTION Failure of the engine or drive shaft as a result of operation without a casing or with a faulty casing cannot be repaired under warranty NOTE Use the cyclic mode when mowing 1 minute full gas mode then 5 10 seconds idling mode

Скачать