Denzel DT 33 [15/95] Derzee

Содержание

Похожие устройства

DERZEE GASOLINE TRIMMER insert the free ends of the cord into the holes of the coil cover install the spring spool in the coil body fix the cover with a sharp movement pull the ends of the cord out of the reel by 1 2 cm so that the cord comes out of the slots of the spool and the spool moves to the working position When the cord is correctly wound and the coil is assembled while the free ends of the cord are pulled out and the coil button is briefly pressed the cord should be released 20 25 mm After refilling the cord if necessary cut off the excess free cord so that the ends have the same length of not more than 20 cm Cutting blade The trimmer is equipped with a 3 blade metal cutting knife A metal knife is used to mow thick grass or weeds To prevent kickback and destruction of the knife do not use it to cut bushes or young trees It is not recommended to work with a knife if the site has large irregularities a bumpy surface deep pits or ditches It is not recommended to work with a knife near trees shrubs hedges If the knife touches a hard obstacle the trimmer will be thrown to the side with the risk of injury Collision of a rotating knife with stones and other extraneous hard objects in the grass as a rule leads to the ejection of their fragments in an unpredictable direction with great speed which can lead to serious injuries ATTENTION It is forbidden to work with a blunt knife It is forbidden to work with a knife that has cracks chips or different lengths of blades It is forbidden to work with a knife fixed with worn or damaged nuts or washers Remember a metal knife rotating with great frequency with the destruction or spontaneous disconnection from the trimmer is a great danger If you experience increased vibration on the knife during operation immediately stop the engine and check the installation and integrity of the knife otherwise this may cause the trimmer to break ATTENTION If the knife hits an obstacle immediately stop the engine and check the knife for damage After work clean the trimmer from the remnants of the mowed grass especially carefully clean the wound grass from the knife axis When cleaning the axle in some cases it is required to remove the knife Note that the axis has a left hand thread and when removing the knife you must rotate the nut clockwise locking the axis as indicated in the Installing the knife section of this manual A ATTENTION To avoid unbalance of the knife it is not recommended to sharpen the knife in the domestic environment without special equipment If the knife is blunt or the cutting edges are damaged replace the knife with a new one MAINTENANCE A ATTENTION All maintenance work on the trimmer except for the items listed in these maintenance and operating instructions must be performed by an authorized service center Maintenance dates are for normal use only Under extreme operating conditions heavy dust heavy loads or longer daily work the specified intervals should be reduced The types of work performed and the service time are shown in the table below

Скачать