Festool BHC 18 Li-Basic (574723) без акк. и з.у [13/62] Caution

Festool BHC 18 Li-Basic (574723) [13/62] Caution
BHC 18
13
GB
7 Settings
7.1 Changing direction of rotation [1-3]
Switch to the left = clockwise rotation
Switch to the right = counterclockwise rotation
7.2 Selecting the operating mode
Hammer drilling
Set selector switch
[1-5]
to hammer sym-
bol.
Screwdriving/drilling
Set selector switch
[1-5]
to drill symbol.
8 Tool holder, attachments
8.1 Changing tools [3]
The SDS-plus system clamps drilling tools in
position without requiring a tool wrench.
Inserting the tool
Clean the tool shank and apply a coating of mul-
tipurpose grease.
Do
[1-2] not
retract the release sleeve, but in-
sert the tool in the tool holder
[1-1]
and turn un-
til it engages.
Check that the tool is seated correctly.
Removing the tool
Pull back the release sleeve
[1-2]
and remove
the tool.
8.2 CENTROTEC tool chuck [4]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CENTRO-
TEC tool chucks.
Before working with the CENTROTEC tool
chuck, set the selector switch
[1-5]
to the drill
symbol.
8.3 Auxiliary handle [1-11]
We recommend working with an auxiliary
handle
[7-1]
to ensure a safe, non-tiring
working posture.
Attaching the auxiliary handle [7]
Attach the auxiliary handle
[7-1]
to the neck of
the gear housing.
Turn the grip anticlockwise until the auxiliary
handle
[7-1]
is secured in position.
8.4 Depth stop [1-12]
The drilling depth can be adjusted using the
depth stop
[7-2]
.
Attaching the depth stop [7-2]
Unscrew the auxiliary handle
[7-1]
by turning
the grip anticlockwise.
Insert the depth stop
[7-2]
in the auxiliary han-
dle
[7-1]
.
Pull out the depth stop
[7-2]
until the distance
between the tip of the drill and the tip of the
depth stop corresponds to the desired drilling
depth.
Tighten the grip on the auxiliary handle
[7-1]
again.
8.5 Extraction
Please observe the safety regulations applicable
in your country for dust. The relevant limit values
must be observed at the workstation.
A dust ex-
tractor may be required for corresponding dust ex-
posure and depending on regulations. Festool of-
fers a drilling dust nozzle in the accessories sys-
tem.
9 Working with the machine
LED red – lit continuously:
bat-
tery, electronics or motor tem-
perature is outside the
permitted range.
LED red – flashing:
indicates a
general fault, e.g. incomplete
contact, short circuit, battery
pack faulty, etc.
WARNING
Risk of injury
Always disconnect the battery pack before per-
forming any type of work on the machine!
CAUTION
Hot and sharp tools
Risk of injury
Do not use insert tools that are blunt or defec-
tive.
Wear protective gloves.
WARNING
Risk of injury
Always secure the workpiece in such a manner
that it cannot move while being machined.

Содержание

Похожие устройства

Скачать