Nissei DS-1011 [49/60] Procedure for the measurement

Nissei DS-1011 [49/60] Procedure for the measurement
49
ENG
Fig.11
5 If you are wearing a shirt that might restrict circulation in your
upper arm or you roll your sleeve up over the upper arm, the blood
ow will be restricted, preventing accurate measurement (fi g.11).
PROCEDURE FOR THE MEASUREMENT
IMPORTANT! The device has sensor keys and clicking is a slight touch
of a fi nger.
Moisture, dirt and other objects between the fi nger and panel of the
device can aff ect the ability to respond to the touching keys.
1. Insert AIR PLUG into AIR CONNECTOR before starting a blood
pressure measurement.
Take deep breaths and relax. Do not move, chat or strain your arm or hand
during measurement.
2. Touch “START/STOP”. Air is exhausted from the cuff (fi g.12).
3. Automatic infl ation starts (fi g.13).
4. Infl ation stops when the pressure, that is, the displayed value, reaches
the designated value.
Body Motion Symbol
Blood pressure value taken while moving cannot be said to be
the correct value because body movement can aff ect blood pressure.
This product analyzes pulse wave and displays « » when body motion is
detected. « » indicates the results might be aff ected by body movement.
Touch “START/STOP” again to cancel measurement. The monitor will
exhaust air from the cuff and turn off .
5. Pulse Symbol
«» is displayed as pulse is detected (fi g.14).
6.
Air is released from the cuff and measured values are displayed as
measurement completes (fi g.15).
7. Touching or will switch the bank.
8. Touch “START/STOP”.
The monitor will be turned off . Even if you do not turn off
the monitor, it turns off automatically after 3 minutes.
Do not execute repeated measurements for congestion
of blood could result in false measurement.
Let your wrist rest for at least 5 minutes.
Fig.14
Fig.15
Fig.12
Fig.13

Содержание