Nissei DS-1011 [51/60] Memory function

Nissei DS-1011 [51/60] Memory function
51
ENG
Personal mode
The infl ation is adjusted based on the latest three readings in the selected bank, either
or , to shorten the measurement time and to improve comfort (fi g.19).
For example, high diastolic blood pressure values from past three measurements will lead
to infl ation to higher pressure value than the default value. In the event that this value is too high
for your current blood pressure, the cuff will rapidly defl ate and measurement will restart.
To use the personal mode eff ectively, chose the memory bank before starting a measurement.
This monitor remembers the last memory bank that was displayed. To choose the memory bank
before starting a measurement, display a reading saved in the desired memory bank, turn off
the monitor once and then start measurement.
MEMORY FUNCTION
The measured values are automatically saved for later review in either
one of two memory banks. These two memory banks can be used to
save readings of two persons separately or to save morning readings
and evening readings separately.
Each bank can save up to 60 readings. When the number of stored readings
reaches 60, the oldest reading will be deleted to record new reading.
Saved readings are recalled with measurement date and time when
clock function is activated. *The clock needs to be activated before
measurement for date and time to be saved with the measured valued.
[Err] results are not saved.
1 Turn off the monitor once with “START/STOP” when the results are
displayed after a measurement
. Touch to review readings saved in
memory 1 and to review those in memory 2.
The average of the saved readings are displayed (fi g. 20).
Average will not be displayed unless there are two or more readings
saved.
2 Touch the same memory key again. The latest reading saved in the
selected bank is displayed.
3 The display at the top shows memory number, measurement date
and time alternately.
4 The latest reading is displayed as memory “No. 1”. The bigger memory
number indicates the older number.
Even if you do not turn off the monitor, it displays the result for approximately 30 seconds and will turn
off automatically.
Touching at display of reading in the bank M1 will switch the display to reading in bank M2 and
touching side again will return to the display of result in the bank M1.
5 Touch “START/STOP” .
Deleting saved readings
The readings can be deleted from the memory. The memory can be initialized only when two or
more results are saved in the bank.
1 Touch
to delete reading in MEMORY 1 or to delete reading in MEMORY 2. Display the
average reading of to delete entire readings in the memory.
2 The display will start fl ashing. Keep your fi nger on the key until the reading is replaced with «---».
Fig.19
Fig.20

Содержание