Elenberg MX-339 [16/20] Din front rear mount

Balance variable range is 10L ~ 10R (21 STEPS) which can be ad-

justed in steps.

5) FADER CONTROL

Press SEL button to select “FAD” on the display and turning the VOL

button to adjust front or rear channel volume.

Fader variable range is 10F ~10R (21 STEPS) which can be adjusted

in steps.

NOTE:

• Choose the mounting location where the unit will not interfere with the

normal driving function of the driver.

• Before ﬁnally installing the unit, connect the wiring temporarily and

make sure it is all connected up properly and the unit and the system

work properly.

• Use only the parts included with the unit to ensure proper installation.

The use of unauthorized parts can cause malfunctions.

• Consult with your nearest dealer if installation requires the drilling of

holes or other modiﬁcations of the vehicle.

• Install the unit where it does not get in the drive’s way and cannot in-

jure the passenger if there is a sudden stop. Like an emergency stop.

• If installation angle exceeds 30 from horizontal. The unit might not

give its optimum performance.

• Avoid installing the unit where it would be subject to

high temperature, such as from direct sunlight. Or from

hot air. From the heater. Or where it would be subject to dust . Dirt or

excessive vibration.

This unit can be properly installed either from “Front” (conventional DIN

Front-mount) or “Rear” (DIN Rear-mount installation, utilizing threaded

screw holes at the sides of the unit chassis). For detail, refer to the fol-

lowing illustrated installation methods.

DIN FRONT-MOUNT

1.1 Dashboard

1.2 Holder

After inserting the holder into the

dashboard, select the appropri-

ate tab according to the thickness

of the dashboard material and bend

them inwards to secure the holder in

place.

1.3 Screw

INSTALLATION

DIN FRONT/REAR-MOUNT