Oleo-Mac PW 300 HС Инструкция по эксплуатации онлайн [22/120] 91846

Oleo-Mac PW 300 HС Инструкция по эксплуатации онлайн [22/120] 91846
26
Operate the water cleaner, thus starting the washing operations; you only need to activate the lever (24) of the
water gun.
e pressure value can be read from the pressure gauge (3).
If you wish to shift from the operation with hot water to the one with cold water, set the temperature adjusting
knob (27) to “0”.
WARNING
Periodically check the gas oil level in the tank and ll it before it empties completely.
e burner starts to work only after approx. three seconds from the water gun opening and stops when the water
gun is closed or when the set temperature is reached.
5.4 us e W I t h de t e r G e n t s
WARNING
e high pressure cleaner was designed to be used with the detergents recommended by the Manufacturer. Use of other
detergents or chemicals can affect the safety of the high pressure cleaner.
Never suck up liquids, which contain solvents, petrol, diluents, acetone and fuel oil, as these products are highly
inflammable, explosive and toxic when nebulized.
Carefully read the instructions and warnings on the label of the detergent to be used.
Store detergents in a safe place out of childrens reach.
Should detergent come into contact with your eyes, wash immediately with water. Contact a doctor without delay
and remember to take the container of detergent with you.
If detergent is swallowed, do not provoke vomiting. Contact a doctor without delay and remember to take the container
of detergent with you.
When lling the tank with detergent, take care not to spill any detergent on the high pressure cleaner. If this should
happen, wait at least 24 hours before using the high pressure cleaner so that any liquid, which may have entered the
appliance, can evaporate.
e recommended detergents, are over 90% biodegradable.
Remove the plug (31) and by paying attention not to make the uid overow (we recommend to use a funnel only
for this operation), ll the tank (max. capacity of 4.5 l/1.2 US gal) by following the recommendations relating
to the batching that are reported on the detergent packaging; close the tank.
WARNING
During the lling/topping-up operations of the Detergent tank, pay attention not to confuse the tanks. If you pour
detergent into the Diesel tank by mistake, do not use the water cleaner and apply to a Skilled Technician.
As for the use mode, refer to the indications on the detergent packaging.
Rotate the ring nut of the nozzle-holding head (18) as shown in Fig. 1-a and then activate the lever (24) of the
water gun and start to spray the detergent. Rotate the nozzle-holding ring nut (18) as shown in Fig. 2-b to reset
the high-pressure operation.
5.5 In t e r r u p t I n G us e (t o t a l s t o p )
Release the lever (24) on the cleaner gun and the water cleaner will automatically stop.
e water cleaner starts operating normally again when the lever on the cleaner gun is pressed again.
WARNING
It is important to remember that the high pressure cleaner is still operational when it is in Total Stop mode. erefore,
always put the main switch (2) in position “0”, remove the plug from the power outlet, press the lever (24) on the
cleaner gun to eliminate any remaining pressure and lock the safety protection device (25) (Fig. 1 - position S), before
leaving it unattended, even for a short time.
6 sW I t c hI n G of f a n d st o r a G e
After cleaning, switch the water cleaner o and prepare it for storage.
6.1 sW I t c hI nG of f
Use the water cleaner with cold water for a couple of minutes.
Close the tap for the water supply securely.
Empty the water out of the water cleaner by pressing the lever (24) on the cleaner gun for a few seconds.
Put the main switch (2) in position “0”
Remove the plug from the power outlet.

Содержание

Похожие устройства

Скачать