Oleo-Mac PW 300 HС Инструкция по эксплуатации онлайн [23/120] 91846

Oleo-Mac PW 300 HС Инструкция по эксплуатации онлайн [23/120] 91846
27
Press the lever (24) on the cleaner gun to eliminate any remaining pressure in the high-pressure pipe (7).
Wait for the high pressure cleaner to cool down.
WARNING
When the water cleaner is left to cool down, take care that:
- the water cleaner is not left unattended in the presence of unsupervised children, elderly or disabled people.
- the water cleaner is in a stable position and not at risk of falling over.
- the water cleaner is not in contact with inflammable materials, or in their immediate vicinity.
6.2 st o r a G e
Wind up the high-pressure pipe (7) carefully and avoid bending it.
If you have a model with hose reel (4), unlock the device by rotating the ring nut in counter-clockwise direction
(3); wind the hose by rotating the reel in clockwise direction by using the knob (5); lock the device by rotating
the ring nut (3) in clockwise direction.
Wind up the electric power supply cable (14).
Put the water cleaner in a clean and dry place making sure that the electric power supply cable and the high-
pressure pipe are not damaged.
CAUTION
e water cleaner is not frost proof.
In order to prevent the formation of ice inside the water cleaner in cold areas, it is possible to make the high
pressure cleaner take up a motor vehicle grade anti freeze before starting the Switch off” procedures. Contact
a Skilled Technician before attempting this as the pumped liquid could damage the seals in the high-pressure
pump.
If it is not possible to protect the high pressure cleaner in cold areas as described above, it must be brought into
a warm room for the time required to melt any ice which may have formed inside it before attempting to start
it up again.
If these instructions are not followed, the high pressure cleaner may be seriously damaged.
7 cl e a n I n G a n d ma I n t e n a n c e
WARNING
Only start cleaning and maintenance once the instructions in the “Switching off” section have been completed.
It is particularly important to always disconnect the electricity supply.
To safeguard the safety of the high pressure cleaner, only use the original spare parts supplied by the Manufacturer or
those endorsed by him.
e rubber pipes, the coupling and the high-pressure lances are important for safety: only use those endorsed by the
Manufacturer.
7.1 ro u t I n e ma I n t e n a n c e
Follow the instructions in the “Switching off” section and abide by the recommendations in the table below.
INTERVAL FOR MAINTENANCE ACTION
Each time used
Check the supply cable, high-pressure pipe, couplings, cleaner gun, lance pipe.
Should any of these parts appear to be damaged, do not use the high pressure
cleaner and contact a Skilled Technician.
Weekly
Cleaning the water suction lter/gasket (33).
Usually, it is sucient to pass the lter under running water or in a jet of compressed air
to clean it. In more dicult cases, use a lime scale remover or replace the lter. Contact
an authorised service centre for the purchase of a new lter.
e inner water inlet lter must be cleaned by a Skilled Technician (see also paragraph
“Special maintenance”).
Monthly
Clean the nozzle (20).
For cleaning, it is generally enough to pass the supplied pin (19) inside the nozzle
hole. If you do not obtain suitable results, replace the nozzle by applying to an
authorised service centre to buy the spare part. To replace it, use a 14-mm socket
wrench (not supplied).

Содержание

Похожие устройства

Скачать