Beurer FWM45 [14/96] Operation

4. Operation

4.1 Initial use

• Connect the mains part cable to the foot warmer controller.

• Insert the mains part into the socket.

4.2 Switching on

•

The fastest way to warm up the foot warmer is to initially select the highest heat setting (setting 2). The

setting can be reduced later if necessary.

• The foot warmer can, of course, be used at any time, even when it is switched off: its fleecy fabric will warm

the feet if there is no socket nearby.

4.3 Massage settings/heat settings

– Massage only: ( )

Setting I (low): relaxing massage

Setting II (high): invigorating massage

The sliding switch for the heat settings is in the “0”

position.

– Heat only: (

)

Setting I: minimum heat

Setting II: maximum heat

The sliding switch for the massage settings is in the

“0” position.

– Massage with heat: (

)

Massage and heat setting freely selectable.

– No massage or heat:

Both sliding switches are set to “0”.

WARNING

If the foot warmer is being used over several hours, we recommend that

you select the lowest heat setting on the controller to avoid overheating

the feet, which may lead to burns to the skin.

4.4 Switching off

To switch the foot warmer off, set the sliding switch for massage and heat settings to the setting “0” (OFF).

NOTE

If the foot warmer is not in use, set the sliding switch to “0” (OFF). Disconnect the mains part from the

foot warmer. Remove the mains part from the socket.

5. Cleaning and maintenance

WARNING

Before cleaning, always remove the mains part from the socket first.

Then disconnect the mains part cable from the foot warmer controller.

Otherwise, there is a risk of damage.