Al-Ko GTA 4030 [26/112] Caution risk of injury sharp edged and moving appliance parts can lead to injury always wear protective

Al-Ko GTA 4030 [26/112] Caution risk of injury sharp edged and moving appliance parts can lead to injury always wear protective
GB
26 GTA 4030
Storage
7.1 Changing the spool (09, 10)
Replacement spool: Art. no. 113349, set of 2.
Precondition: The appliance must be switched off
and the rechargeable battery must be removed
from the basic appliance.
Inserting and pulling out the spool
1. Press (09/a) the two unlocking buttons (09/1)
at the same time and remove (09/b) the
cover (09/2).
2. Pull out(09/c) the empty spool (09/3).
3. Insert (10/a) the new spool (10/1). At the
same time, make sure that the spring is re-in-
serted.
4. Thread the cutting line (10/2) through the
openings (10/3) of the spool head towards
the outside.
5. Put on the cover (10/4) and press on until it
engages.
6. Insert the rechargeable battery in the basic
appliance.
Bring the cutting line to the required length
1. Switch on the appliance.
2. Tap (04/a) the spool head (04/1) on the
ground from time to time. This unwinds a
piece of new cutting line from the spool.
3. Switch off the appliance and wait until the
cutter head has come to a standstill.
4. Check the line length.
5. Repeat the previous steps until the cutting
line has the required length.
8 STORAGE
Thoroughly clean the appliance after each use
and – if present – attach all covers. Store the ap-
pliance in a dry, lockable place out of the reach of
children.
Carry out the following jobs before intervals in
work lasting for longer than 30 days:
Thoroughly clean the appliance and store it in
a dry place.
9 HELP IN CASE OF MALFUNCTION
CAUTION!
Risk of injury
Sharp-edged and moving
appliance parts can lead to
injury.
Always wear protective
gloves during mainten-
ance, care and cleaning
work.
Malfunc-
tion
Cause Remedy
Additional
cutting line
is not sup-
plied.
Spool is
empty.
Change the spool.
Re-
chargeable
battery op-
erating time
is signific-
antly
shorter.
Grass is too
long or too
wet.
Cut the grass
at a greater
height.
Let the grass
dry.
Cutting
height is too
low.
Cut the grass at a
greater height.
Motor run-
ning, but
the spool
does not
turn.
Appliance
faults
Contact an AL-KO
service centre.
Appliance
vibrates un-
usually.
Spool is con-
taminated.
Clean the spool,
renew it if neces-
sary.
Appliance
faults
Contact an AL-KO
service centre.
Other faults See "Multitool MT 40 – basic ap-
pliance" operating instructions.
NOTE
If you encounter any malfunctions that
are not listed in this table or that you
cannot rectify yourself, please contact
our customer service.

Содержание

Скачать