Al-Ko KHS 5204 [19/140] Troubleshooting

Al-Ko KHS 5204 [19/140] Troubleshooting
Troubleshooting
462706_i 19
TROUBLESHOOTING
If malfunctions occur, switch off the log splitter and disconnect the mains plug. Malfunctions that cannot
be rectified with reference to the following table must be rectified by an authorised specialist company.
Fault Cause Solution
Insufficient hydraulic oil Refill hydraulic oil
Hydraulic pump defective Renew hydraulic pump
Log pusher does not move
out/in
Machine is at an angle sloping
down towards the splitter wedge
Set the machine horizontal or slo-
ping down towards the operating
lever
Insufficient hydraulic oil Refill hydraulic oilLog pusher has no power
Machine is at an angle sloping
down towards the splitter wedge
Set the machine horizontal or slo-
ping down towards the operating
lever
Insufficient hydraulic oil Refill hydraulic oil
Machine is at an angle sloping
down towards the splitter wedge
Set the machine horizontal or slo-
ping down towards the operating
lever
Hydraulic pump whistles,
log pusher moves jerkily
Air in the circuit Open the vent screw
Motor gets very hot Cable cross-section too small Use a cable with a larger cross-
section
Thermal switch has switched off Wait until the motor has cooled
down.
Mains plug or socket defective Have a check performed by an
electrician
Cable defective Renew
Motor does not start
Electric motor defective Have a check performed by an
electrician
TRANSPORT
CAUTION!
Do not transport the log splitter on the cy-
linder fastening.
CAUTION!
Pull out the unit plug and tighten the vent
screw prior to every change of location.
Hold the log splitter on the transport bracket
to transport
DISPOSAL
Do not dispose of worn-out machines
or spent batteries (including recharge-
able batteries) in domestic waste!
The packaging, machine and accessories
are made from recyclable materials and
must be disposed of accordingly.

Содержание

Скачать