Infiniti G35 Coupe (2007) [113/328] Button
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Infiniti G35 Coupe (2007) [113/328] Button

Infiniti G35 Coupe (2007) [113/328] Button
teries with new batteries.
O position the hand-held transmitter
with its battery area facing away from
the HomeLink
surface.
O push and hold both the HomeLink
and hand-held transmitter buttons
without interruption.
O position the hand-held transmitter 2
to 5 in (50 to 127 mm) away from the
HomeLink
surface. Hold the transmit-
ter in that position for up to 15 sec-
onds. If HomeLink
is not pro-
grammed within that time, try holding
the transmitter in another position -
keeping the indicator light in view at
all times.
If you continue to have programming diffi-
culties, please contact the INFINITI Con-
sumer Affairs Department. The phone
numbers are located in the Foreword of
this Owner’s Manual.
CLEARING THE PROGRAMMED
INFORMATION
Individual buttons cannot be cleared,
however to clear all programming, push
and hold the two outside buttons and re-
lease when the indicator light begins to
flash (approximately 20 seconds).
REPROGRAMMING A SINGLE
HomeLink
BUTTON
To reprogram a HomeLink Universal
Transceiver button, complete the fol-
lowing.
1. Push and hold the desired HomeLink
button. Do not release the button until
step 4 has been completed.
2. When the indicator light begins to
flash slowly (after 20 seconds), posi-
tion the hand-held transmitter 2 to 5
in (50 to 127 mm) away from the
HomeLink
surface.
3. Push and hold the hand-held trans-
mitter button.
4. The HomeLink
indicator light will
flash, first slowly and then rapidly.
When the indicator light begins to
flash rapidly, release both buttons.
The HomeLink
Universal Transceiver but-
ton has now been reprogrammed. The
new device can be activated by pushing
the HomeLink
button that was just pro-
grammed. This procedure will not affect
any other programmed HomeLink
but-
tons.
IF YOUR VEHICLE IS STOLEN
If your vehicle is stolen, you should change
the codes of any non-rolling code device
that has been programmed into HomeLink
.
Consult the Owner’s Manual of each device
or call the manufacturer or dealer of those
devices for additional information.
When your vehicle is recovered, you will
need to reprogram the HomeLink
Uni-
versal Transceiver with your new transmit-
ter information.
FCC Notice:
This device complies with FCC rules part
15. Operation is subject to the following
two conditions: (1) This device may not
cause harmful interference and (2) This de-
vice must accept any interference that may
be received, including interference that
may cause undesired operation.
The transmitter has been tested and com-
plies with FCC and DOC/MDC rules.
Changes or modifications not expressly
approved by the party responsible for com-
pliance could void the user’s authority to
operate the device.
DOC: ISTC 1763K1313
FCC I.D.: CB2V67690
Instruments and controls 2-45
w 06.6.30/V35-D/V5.0 X

Содержание

Похожие устройства

Скачать