Infiniti FX45 (2006) [114/392] Button
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Infiniti FX45 (2006) [114/392] Button

Infiniti FX45 (2006) [114/392] Button
tinue to press and hold the HomeLink but-
ton (note steps 2 through 4 under “Pro-
gramming HomeLink
”) while you press
and re-press (“cycle”) your hand-held
transmitter every 2 seconds until the indi-
cator light flashes rapidly (indicating suc-
cessful programming).
NOTE:
If programming a garage door opener,
etc., it is advised to unplug the device dur-
ing the “cycling” process to prevent pos-
sible damage to the garage door opener
components.
OPERATING THE HomeLink
UNIVERSAL TRANSCEIVER
The HomeLink Universal Transceiver
(once programmed) may now be used to
activate the garage door, etc. To operate,
simply press the appropriate programmed
HomeLink
Universal Transceiver button.
The red indicator light will illuminate while
the signal is being transmitted.
PROGRAMMING TROUBLE-
DIAGNOSIS
If the HomeLink does not quickly learn
the hand-held transmitter information:
O replace the hand-held transmitter bat-
teries with new batteries.
O position the hand-held transmitter with
its battery area facing away from the
HomeLink
surface.
O press and hold both the HomeLink
and hand-held transmitter buttons
without interruption.
O position the hand-held transmitter 2 to
5 inches (50 to 127 mm) away from the
HomeLink
surface. Hold the trans-
mitter in that position for up to 15 sec-
onds. If HomeLink
is not programmed
within that time, try holding the trans-
mitter in another position - keeping the
indicator light in view at all times.
If you continue to have programming diffi-
culties, please contact the INFINITI Con-
sumer Affairs Department. The phone num-
bers are located in the Foreword of this
Owner’s Manual.
CLEARING THE PROGRAMMED
INFORMATION
Individual buttons cannot be cleared, how-
ever to clear all programming, press and
hold the two outside buttons and release
when the indicator light begins to flash
(approximately 20 seconds).
REPROGRAMMING A SINGLE
HomeLink
BUTTON
To reprogram a HomeLink Universal
Transceiver button, complete the fol-
lowing.
1. Press and hold the desired HomeLink
button. Do not release the button until
step 4 has been completed.
2. When the indicator light begins to flash
slowly (after 20 seconds), position the
hand-held transmitter 2 to 5 inches (50
to 127 mm) away from the HomeLink
surface.
3. Press and hold the hand-held trans-
mitter button.
4. The HomeLink
indicator light will
flash, first slowly and then rapidly.
When the indicator light begins to flash
rapidly, release both buttons.
The HomeLink Universal Transceiver
button has now been reprogrammed. The
new device can be activated by pushing the
HomeLink
button that was just pro-
grammed. This procedure will not affect any
other programmed HomeLink
buttons.
2-50 Instruments and controls
Z 05.11.1/S50-D/V5.0 X

Содержание

Похожие устройства

Скачать