Infiniti FX45 (2006) [80/392] Front passenger air bag status light
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Infiniti FX45 (2006) [80/392] Front passenger air bag status light

Infiniti FX35 (2006) [80/392] Front passenger air bag status light
Front passenger air bag
status light
The front passenger air bag status light
(
) will be lit and the passenger front
air bag will be OFF depending on how the
front passenger seat is being used.
For front passenger air bag status light op-
eration, see “INFINITI advanced air bag
system” in the “1. Safety — Seats, seat
belts and supplemental restraint system”
section of this manual.
High beam indicator light
(Blue)
This light comes on when the headlight
high beam is on and goes out when the low
beam is selected.
Intelligent Cruise Control
system MAIN switch
indicator light (Green; if so
equipped)
The light comes on when the ICC system
MAIN switch is pushed. The light goes out
when the MAIN switch is pushed again.
While the MAIN switch indicator light comes
on, the ICC system is operational.
Intelligent Cruise Control
system set switch indicator
light (if so equipped)
The light comes on while the vehicle speed
is controlled by the Intelligent Cruise Con-
trol system. If the light blinks while the en-
gine is running, it may indicate the Intelli-
gent Cruise Control system is not func-
tioning properly. Have the system checked
by an INFINITI dealer.
Malfunction indicator lamp
(MIL)
If the malfunction indicator lamp comes on
steady or blinks while the engine is run-
ning, it may indicate a potential emission
control malfunction.
The malfunction indicator lamp may also
come on steady if the fuel-filler cap is loose
or missing, or if the vehicle runs out of fuel.
Check to make sure the fuel-filler cap is in-
stalled and closed tightly, and that the ve-
hicle has at least three gallons of fuel in the
fuel tank.
After a few driving trips, the
lamp
should turn off if no other potential emis-
sion control system malfunction exists.
If this indicator lamp comes on steady for 20
seconds and then blinks for 10 seconds when
the engine is not running, it indicates that the
vehicle is not ready for an emission control
system inspection/maintenance test. See
“Readiness for inspection/maintenance (I/M)
test” in the “9. Technical and consumer infor-
mation” section of this manual.
Operation
The malfunction indicator lamp will come
on in one of two ways:
O Malfunction indicator lamp on steady —
An emission control system malfunc-
tion has been detected. Check the fuel-
filler cap. If the fuel-filler cap is loose or
missing, tighten or install the cap and
continue to drive the vehicle. The
lamp should turn off after a few
driving trips. If the
lamp does not
turn off after a few driving trips, have
the vehicle inspected by an INFINITI
dealer. You do not need to have your ve-
hicle towed to the dealer.
O Malfunction indicator lamp blinking —
An engine misfire has been detected
which may damage the emission con-
trol system. To reduce or avoid emis-
sion control system damage:
a) Do not drive at speeds above 45
MPH (72 km/h).
2-16 Instruments and controls
Z 05.11.1/S50-D/V5.0 X

Содержание

Похожие устройства

Скачать