Nuova Simonelli Mythos Plus stainless steel [26/66] Mythos

MYTHOS

7.4.10

PASSWORD ENTRY

The new software version includes the possibility to enter a password to prevent access to

programming. Once on the "EDIT PSW" page, it is possible to enter or change a password

by pressing the flashing key

. At this point, there are 2 options:

1) Entering a new password; on the "NEW PSW" page, all keys will be flashing and

it is therefore possible to enter a combination, using the flashing keys to create

a sequence. The length of the password in terms of “characters” (keys) entered,

can vary from zero (password disabled) to eight (8). To enter a “character” in the

sequence, it is necessary to press and immediately release the required key; the dis-

play will show an asterisk (*) symbol. To store the sequence, it is necessary to press

and hold down the key

for about three seconds. If the sequence is not entered

and only the empty page is stored, no password will be used. On the next page,

"CONFIRM PSW" a password confirmation will be requested; proceed as described

above, entering the same sequence, storing it to memory with the

key

2) Changing a previous password. On the "ENTER PSW" page, it is first necessary

to enter and confirm the previous password before following the instructions provided

in point 1.

Once the password has been entered, it will be requested for access to any programming

function (See Par. 7.4.5 SETTING GRINDING TIMES). Once entered, the sequence needs

to be confirmed with the

key.

If the password entered is not correct, the display will read "PSW ERROR" for about 3 sec-

onds before returning to its previous mode.

If the machine should switch off accidentally, the password will remain stored in the memory

only if after the “store” step has been completed during "CONFIRM PSW".

If the user forgets the password, it is possible to access the programming function using

the "RELEASE CODE": press and hold down (for 10 seconds) the

keys; after

about 2 seconds, the display will show the message "ENTER PSW", then after 10

seconds, the message "RELEASE CODE" will appear. At this point, it is possible to enter

the following sequence:

then press the

, key to confirm; this will disable the previously set password and make

it possible to access the programming function.

The whole "PASSWORD" function is active for all operating modes; in the "MANUAL" and

"AUTOMATIC" modes it blocks access to all programming. However, in "BARISTA" mode

it is still possible to edit dose times but it is not possible to access counters.

There is no limit to the error of entering the password.

