Dreame Bot Robot Vacuum and Mop D10 Plus (RLS3D) [10/111] Routine maintenance

14 15

ENEN

Clean the Dust Bin

Clean the Filter

Routine Maintenance

1. Open the robot cover, then press the dust

bin clip to remove the dust bin.

2. Open the bin cover and empty the

bin as shown in the diagram.

3. Clean the dust intake.

2. Do not wash the lter. Only the dust bin is washable. Thoroughly dry it before re-installing.

1. Remove the lter and tap its basket gently.

Note:

· Do not attempt to clean the lter with brushes or ngers.

· Rinse the dust bin with clean water only. Do not use any detergent.

· Use the dust bin and lter when they are completely dry.

· The lter is recommended to be cleaned every two weeks and replaced every three months.

Clean the Mopping Module

Routine Maintenance

1. Press the two release clips on the side of the water tank, remove the

mopping module, and pull the mop pad o the mopping module.

3. Clean the mop pad with water only and leave to air dry before re-installing.

2. Pour out the water in the tank. Clean with only water and leave out to air

dry before re-installing.

4. If slow water ow occurs, or the volume is not well-distributed, clean the air

hole in the cover of the water tank.

Note: Do not expose the tank to the sun directly.

Note:

• Remove the pad from the mopping module before cleaning it, and make sure

dirty water does not ow back into the water outlet to avoid clogging.

• For optimal performance, it is recommended to replace the mop pad every 3-6

months.

* Clean after each use