Vitek Safari VT-8248 [5/40] English

ENGLISH

• Do not use the unit if the power plug or the power cord

is damaged, if the unit operates improperly or after it

was dropped.

• Do not attempt to repair the unit. Do not disassemble the

unit by yourself, if any malfunction is detected or after it

was dropped, unplug the unit and apply to any autho-

rized service center at the contact addresses given in

the warranty certificate and on the website www.vitek.ru.

• To avoid damages, transport the unit in the original

package only.

• Keep the unit in a dry cool place out of reach of children

and disabled persons.

THIS UNIT IS INTENDED FOR HOUSEHOLD USE ONLY.

ITS COMMERCIAL USAGE AND USAGE IN PRODUCTION

AREAS AND WORK SPACES ARE PROHIBITED.

USING THE HOT AIR BRUSH

After unit transportation or storage at low temperature

keep it for at least three hours at room temperature

before switching on.

• Unpack the hot air brush and remove any stickers that

can prevent unit operation.

• Unwind the power cord completely.

• Install one of the attachments (7), (8), (9) or (10). To do

this insert the attachment into the hot air brush body (4)

and turn it clockwise. If the attachment is set properly,

you will hear the lock button (1) click.

• Before switching the unit on, make sure that your home

mains voltage corresponds to the unit operating voltage.

• Make sure that the operation mode switch (2) is set to

the position “0”.

• Insert the power plug into the mains socket.

• Set the required settings of the air flow using the

switch (2):

«0» – the hot air brush is switched off;

«1» – high air flow speed and low temperature;

«2» – low speed and low temperature;

«3» – high speed and high temperature.

• The cool shot mode is activated with the switch (2). To

activate the cool shot mode, slide the switch (2) towards

the attachment. To deactivate the cool shot mode, slide

the switch (2) down.