Crown CT13507-150N [22/156] Environmental protection
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Crown CT13507-150N [22/156] Environmental protection

Crown CT13507-150N [22/156] Environmental protection
22
English
• Screw clamping nut 16 onto spindle 13 and tighten
it with ange wrench 10� Attention: at mounting
any accessories over 4 mm thick clamping nut 16
should be turned over (see g. 3).
• Release spindle lock 3�
Initial operation of the power tools
Always use the correct supply voltage: the power
supply voltage must match the information quoted on
the power tool identication plate.
Switching the power tool on / off
Switching on:
In order to switch on the power tool, push lock-off but-
ton 8 and while holding it in position, push switch but-
ton 7�
Switching off:
In order to switch off the power tool, release switch
button 7�
Recommendations on the power tool
operation
Cutting (see g. 5-6)
• Install cutting disc as described below�
• Start the power tool, wait until the engine gains its
maximum speed and only after that, smoothly bring
cutting disc to the surface processed�
• Do not apply excessive pressure to the power tool,
as it will not bring better results but it will overload the
engine and wear out cutting disc faster�
• Move the power tool along the cutting line with
moderate feed, not distorting and not making vibrating
and bursting movements�
• Cutting should be implemented in the direction
shown on g. 5. When cutting in the reverse direction
the danger of uncontrolled throwing of the power
tool out to the side of the operator, which can lead to
serious injuries appears (see g. 6).
Grinding (see g. 7)
Grinding is applied for the rough and quick grinding of
metals, the processing of welding seams, etc� Select
the type of grinding disc depending on the work, which
you are going to implement�
• Install grinding disc as described above�
• Start the power tool, wait until the engine gains its
maximum speed and only after that smoothly bring
grinding disc to the surface processed�
• Holding the power tool at an angle of 10° to 15°
relating to the surface processed (see g. 7) is
recommended� If this angle is less than recommended,
it will make controlling the power tool more difcult. If
this angle is more than recommended, the processing
quality will decrease and grooves will be left on the
billet surface�
• Make alternate-reciprocal movements applying
moderate pressure to the power tool� Excessive
pressure will not bring better results but it will overload
the engine and create the danger of destruction of
grinding disc, which can cause severe injuries�
Power tool maintenance / preventive
measures
Before carrying out any works on the power tool it
must be disconnected from the mains�
Cleaning of the power tool
An indispensable condition for a safe long-term
exploitation of the power tool is to keep it clean� During
the long treatment of metal, current-conducting dust
can be accumulated inside the power tool� Regularly
ush the power tool with compressed air thought the
ventilation slots 4�
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.crown-tools.com.
Transportation of the power tools
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use
any kind of technology that works on the principle of
clamping packaging�
Environmental protection
Recycle raw materials instead of
disposing as waste.
Power tool, accessories and packaging
should be sorted for environment - friendly
recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper
manufactured without chlorine�
The manufacturer reserves the possibility to introduce changes.

Содержание

Похожие устройства

Скачать