Ada PROF SET LaserTANK 3-360 + Cosmo 50 + SILVER PLUS + LASERMARKER 70 + Laser STAFF для уличных работ А00735 PDF-инструкция онлайн [7/28] 818938

7English

3. The slope mode is activated when the pendulum is locked. Set the pendulum

switch (7) up to the (OFF) position. Press and hold button (13) for 2 sec to

activate a slope mode (upper horizontal laser line is ON, indicator is ON, all

switched on laser lines will blink one time per sec.). The tool can be installed

at any angle. Switch On/Off laser lines with the laser line buttons.

Press button (13) to switch off a slope mode. Indicator (14) will be switched off.

4. Press button (12) once. Detector mode is activated. Indicator (11) is ON.

Use a detector for operation in this mode. Follow an operating manual

to use the detector. Press button (12) to switch OFF the detector mode.

Indicator (11) is OFF.

5. Attach the line laser to the tripod with the help of the thread 1/4” on the

upper or bottom part of the tool.

USING THE REMOTE CONTROL

1. To control the functions of the device, the remote control must be paired

with the device. If the remote control does not control the instrument

functions, follow these steps:

• Be sure that the battery is full. If necessary, change it into new one:

unscrew the screws on the back cover of the remote and remove

it. Place new battery, observe the polarity. Screw the cover with the

screws. If you cannot replace the battery yourself, contact the nearest

service center.

•

To connect the remote control to the device, unlock the pendulum:

move the pendulum switch (8) to the (ON) position. Press and hold

button (13) for more than 2 sec. Indicator (12) starts blinking frequently.

Press On/Off (2) button on the remote control. Indicator (12) will be

switched off/ The remote will be connected to the line laser.

2. Use the remote control to switch on/off laser lines:

•

Press button (2) once – all laser beams on will be turned off. Press

button (2) once again – all laser beams that worked before turning