GRAPHITE delta 105 Вт, подошва 140x97мм 59G335 [11/68] Operation settings

PREPARATION FOR OPERATION

INSTALLATION OF SANDING PAPER

The sander is equipped with pad with so called hook-and-loop, only appropriate sanding paper should be

used.

Ɣ Put the sanding paper close to the backing pad (3).

Ɣ Place the sanding paper so it’s holes (a) match holes on the sander backing pad.

Ɣ Press the paper against the backing pad (3) (g. A).

Ɣ Ensure that the holes on the sanding paper and backing pad fully match; it ensures possibility of dust

extraction.

Sanding paper must thoroughly adhere to the sander backing pad.

DUST EXTRACTION

Use perforated sanding paper, so the dust can reach the dust extraction outlet (2) through the backing pad

(3). You can also use external dust extraction system by connecting it to the adaptor (4).

OPERATION / SETTINGS

SWITCHING ON / SWITCHING OFF

The mains voltage must match the voltage on the rating plate of the sander.

Ɣ Switching on – press the switch button (1) to position I (g. B)..

Ɣ Switching o – press the switch button (1) to position O.

WORKING WITH DELTA SANDER

ƔWhole sanding area must rest on the processed surface.

Ɣ Turn the sander on, apply moderate pressure and move it on the processed material.

Ɣ When ﬁnishing to sand, reduce pressure, lift the sander and only after that switch the tool oﬀ.

OPERATION AND MAINTENANCE

Disconnect the tool from power supply network before starting any adjustment, maintenance or

repair.

Ɣ Soft brush or stream of compressed air are best for cleaning the sander.

Ɣ Do not clean with water or cemical cleaning agents.

Ɣ Clean the sander on a regular basis, preferably after each work.

Ɣ Always keep the sander and ventilation holes clean.

Ɣ Always store the sander in a dry place, beyond reach of children.

Ɣ In case of excessive commutator sparking have the technical condition of carbon brushes of the motor

checked by a qualiﬁed person.

REPLACEMENT OF BACKING PAD

Damaged backing pad (3) must be replaced immediately.

Ɣ Unscrew the screws that ﬁx the backing pad (3).

Ɣ Remove and replace the backing pad.

Ɣ Tighten the ﬁxing screws.

REPLACEMENT OF CARBON BRUSHES

Replace immediately worn out (shorter than 5 mm), burnt or cracked motor carbon brushes. Always

replace both brushes at a time.

Entrust replacement of carbon brushes only to a qualied person. Only original parts should be

used.

All faults should be repaired by service workshop authorized by the manufacturer.