Caiman NEMH20 DELUXE [6/16] Installation of charging base

User manual

INSTALLATION AND UNPACKING

UNPACKING

The equipment is delivered suitably packaged. When unpacking, carefully remove and check the integrity of the parts.

The packaging contains all the necessary information for handling the device.

INSTALLATION

•

Remove the robot from the packaging.

•

Place the robot on the ground.

•

Install the charging base and then gently immerse the robot in the pool. Wait until it has settled on the bottom and then, using

the hook provided, place the robot near the charging plate from the front side of the robot, which is identied by a recharging

sticker. If positioned correctly, the red LED and blue LED of the recharger will light up continuously.

•

Recharge the robot for 15 minutes before moving to the programming phase.

•

To program the robot, take it out of the water using the hook provided, place it on the ground and follow the programming

instructions.

•

Once programmed, immerse the robot in the water so that the work cycle can begin.

INSTALLATION OF CHARGING BASE

Remove the charging base from its packaging.

Place the charging base along the vertical wall of the pool.

Important

Position the steel side of the dissipator in contact with the pool wall.

Do not position the charging base on the bottom of the pool.

Make sure that the angle formed between the charging base and the opposite bottom is 90° and that the

area surrounding the recharger (at least 2 meters) is even and horizontal.

OK NO

NO NO