Kramer K202B [14/22] Before installation

Secure 2-Port KVM Switch User Manual

Before Installation

Unpacking the Product

Before opening the product sealed packaging inspect the seal

condition to assure that product was not accessed or tampered

during delivery. If packaging seal looks suspicious contact HSL

support team and do not use the product.

After seal removal inspect packaging content to verify that required

components included. See packaging content list in page 4 above.

After the Secure KVM Switch removed from its packaging materials

carefully inspect the tampering-evident label to assure that product

is properly sealed. If the label is damaged or missing contact HSL

support and do not use that product.

Where to locate the Switch?

Product must be located in a secure and well protected environment

to prevent potential attacker access.

If longer set of cables or if a Secure Fiber Extender (RFE) are used,

KVM Switch may be remotely located in a locked down facility to

prevent unauthorized users access.

Consider the following when deciding where to place the Switch:

 User access to the front panel push-buttons (not needed if

keyboard shortcut is used to switch channels).

 Keyboard and mouse cables length. Cables typically may be

extended to a distance of 4 meters.

 Display cable length. Typically may be extended to around 10

meters without video quality degradation (still depends on

display and cables quality and must be tested prior to fixed

installation).

 The location of the computers in relation to the switch and

the length of available KVM cables (typically 1.8 m)

Note: Due to USB and DVI signal limitations, the cable length cannot

exceed 4.6 m (15 feet).

Warning: Avoid placing cables near fluorescent lights, air-

conditioning equipment, RF equipment or machines that create

electrical noise (e.g., vacuum cleaners).