Kramer TBUS-1Axl [19/26] Inserting the tbus 1axl through the cut out opening

16 TBUS-1Axl - Installing the TBUS-1Axl

5.4 Inserting the TBUS-1Axl through the Cut Out Opening

To install TBUS-1Axl in the opening:

1. Remove the protective rubber guard from around the outer rim of the

TBUS-1Axl housing. Beware of the sharp edge!

2. Carefully insert the unit into the prepared opening (see

Figure 9).

3. Take the support brackets under the table and place them into the support

bracket grooves on both sides of the unit (see

Figure 2, item 7).

4. Verify proper alignment of the unit before tightening the mounting screws.

5. Tighten both mounting butterfly screws upward until they reach the table

surface (from underneath). Tighten firmly (see

Figure 9).

6. Tighten the locking butterfly screws downward until tight against the

mounting bracket.

Figure 9: Inserting TBUS-1Axl into the Prepared Opening

5.5 Connecting the Cables

When replacing blank inserts with connector inserts (for example, VGA, audio,

HDMI and so on):

1. Insert the cables to their appropriate connectors from underneath.