Kramer Sierra Viper 6464CVR-64 [15/88] Installation

SIERRA VIDEO

Installation

Introduction

Installation procedures are similar for all frames covered within this manual. Exceptions, if any,

have been noted in each of the following paragraphs.

Rack Mounting

Carefully inspect the frame to ensure that there has been no shipping damage. Make sure all

shipping material is removed from the router frame.

Each of the routing switchers described in this manual can be rack mounted in a standard 19"

(1RU) EIA rack assembly and includes rack "ears" at the ends of the front of the frames. None of

the switcher models require spacing above or below the unit for ventilation. To rack mount any of

the routing switchers, simply place the unit's rack ears against the rack rails of the rack, and

insert proper rack screws through each of the holes in the rack ears. Always rack mount the

routing switcher prior to plugging the unit into a power receptacle or attaching any cables.

Important; Rear mounting brackets must be installed prior to installation of the router into a

rack. The rear mounting brackets are contained in the accessory kit supplied with your router.

CAUTION!

The operating temperature range of the Viper series router is 0 to 40 °C. Do not exceed the maximum (40

°C) or minimum (0 °C) operating temperature.

Rear mounting brackets must be installed prior to installation of the router into a rack. The rear mounting

brackets are contained in the accessory kit supplied with your router.

If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack

environment may be greater than the room ambient temperature. Therefore, consideration should be

given to installing the equipment in an environment compatible with the manufacturer’s maximum rated

ambient temperature (TMRA).

Installation of the equipment in a rack should be such that the amount of air flow required for safe

operation of the equipment is not compromised.

Chapter