Kramer Sierra Viper 6464CVR-64 [23/88] To set ip parameters using the serial port

VIPER COMPOSITE SERIES

To set IP parameters using the serial port;

1. Connect the COMM port from a computer to “CTRL 2” on the back of the “Master” frame.

2. Open HyperTerminal, Hyper Access or other similar terminal emulation program.

3. Set the program’s parameters to 115.2K baud, 8 Data bits, No parity, 1 stop bit, ANSI emulation.

4. Establish communication to the router’s processor by pressing the “Esc” button on the keyboard.

The terminal program screen will re-write confirming communication.

5. Turn the power off to the “Master” frame, leaving the terminal program running.

6. Remove the CPU board and set DIP switches S1-1 and S1-2, on the processor module, to on.

7. Replace the CPU board.

8. Turn power to the “Master” frame on.

9. The processor will begin to boot.

10. Within the first 4 seconds of boot-up when the processor is turned on, press the keyboard

spacebar. This will interrupt the booting of the unit and enter the configuration menu.

11. Press “0” and enter the IP information, then press ENTER.

12. Turn the “Master” frame off, remove the CPU and set the DIP switches S-1 and S1-2 back to the

off position.

13. Replace the board and power the frame up.

Note:

The Ethernet port accepts HOST protocol commands to switch the router. See the

section of this manual on Protocol for information on Host protocol commands.

*If your server is capable of IP reservations by the MAC address you can enable the DHCP option. It is

advisable to contact the Factory for further information regarding this feature.