Kramer Sierra Viper 6464CVR-64 [17/88] Connecting to video devices

VIPER COMPOSITE SERIES

Connecting To Video Devices

Video sources and output devices (such as monitors, or recorders) may be connected to the

routing switchers through the BNC type connectors located on the back of the unit. Keep in mind

that the output signal format will be that of the input signal format.

All signal connections that use more than one cable interconnecting between devices should be

of equal timing length (example: cables between a camera and the switcher should have the

same time delay).

Reference Sync

There are three “looped” sets of BNC connectors labeled "VIDEO REF 1", “VIDEO REF 2””.

These are "looping" inputs for sync referencing. Connect either composite sync or video with sync

to either set of BNCs. If desired, use the second BNC in the set to loop the signal to another

device. If the loop is not used, terminate the second BNC with 75 ohms.

The set of sync connectors labeled “VIDEO REF 2” is for future use and are not

connected.

If no sync is available, the routing switcher will switch at a random point rather than during the

vertical interval of the reference signal.

Note:

Reference sync need only be connected to the “Master” frame in a multi-frame system. The “Master”

frame is the frame where the processor is installed.