Smeg SRV876C6 [13/18] Instructions for the installer

Instructions for the installer

6 FINAL OPERATIONS

Having carried out the above adjustments, reassemble the appliance

following, backwards, the instructions in paragraph “

5.1 Removing the

hob”.

6.1 Regulation of minimum for natural gas

Replace the components on the burner and

slide the knobs on the gas tap pins. Light the

burner and set it at minimum position. Remove

the knob and turn the regulation screw inside or

next to the gas tap pin (depending on the

model) until you get a suitable minimum flame.

Replace the knob and check burner flame

stability: (rapidly turning the knob from

maximum to minimum position, the flame

should not go out).

6.2 Regulation of minimum for LPG

To regulate the minimum for LPG, completely tighten (clockwise) the

screw inside or next to the gas tap pin (depending on the model).

The diameters of the by-passes for each burner are given in table “

5.2

Regulation for LPG”.

After having regulated the device with a gas other than the one tested,

replace the label located on the bottom enclosure with the one that

corresponds to the new gas. The label is inside the bag that contains

the nozzles.